ACC SNAplus2 Link Software User's Guide

Chapter 3 33

Using SNAplus2 via SNA/ACC

Checking SNAplus2 Status

If the new kernel has booted successfully (Chapter 2, Section Software

Installation, Step #8), the SN Aplus2 software is probably running. Use

the following command to check for the status of SNAplus2 on your

system:

/opt/sna/bin/X11/xsnapadmin

NOTE Use of xsnapadmin requires Motif interface software and a bit-mapped

display to run X11. Use snapadmin as an alternative if necessary.

The xsnapadmin window appears as shown in Figure 3-1. If the

SNAplus2 software is not running, issue the following command to

manually start SNAplus2:

/opt/sna/bin/snap start

If this is unsuccessful, refer to the HP-UX SNAplus2 Installation Guide

for detailed procedures.