ACC SNAplus2 Link Software User's Guide

30 Chapter2
Software Installation and Verification
Installation Verification
Step 5. Make the following selections under “Connectivity” in the “New link
station” window:
Add link station to: SDLCP0
Name: SDLCL1
SNA port name: SDLCP1
Activation: By administrator
LU traffic: Independent only
Remote node... USHWP01.ACCP01
Contact information:
Poll address: C1
SNAplus2 Over SNA/ACC Verification
Use the xsnapadmin program to activate the ports and link stations:
1. Activate the node first.
2. Activate the ports .
3. Activate the primary link station first. (Use the Zoom feature in the
GUI if you need to configure a station as primary.)
4. Activate the primary link station first. (Use the Zoom feature in the
GUI if you need to configure a station as primary.)
5. While the primary link station is “Starting”, activate the secondary
link station.
In its “Connectivity and dependent LUs” section, the xsnapadmin screen
should show the status of both ports and link stations as “Active” when
the verification procedure has been successful.