ACC SNAplus2 Link Software User's Guide

26 Chapter2
Software Installation and Verification
Installation Verification
NOTE Versions of SNA/ACC prior to B02.40 dynamically handled the creating
of terminal definitions. Versions of SNA/ACC for 3.02 and above require
the user to define terminals statically in the .answ files as illustrated in
the example .answ file. You must add the Term entries to your .answ file
and modify them appropriately for your configuration requirements.
Bringing Up ZCOM
Before any of the features of the ZCOM Mux Subsystem can be accessed,
it must be started up by running zmasterd (located in /opt/acc/bin)
with an appropriate .tmem file. The /opt/acc/cfg/loopback.tmem file
should be used. Invoke zmasterd as follows:
% zmasterd cold /opt/acc/cfg/loopback.tmem
Messages indicating whether or not the ZCOM Mux subsystem was
started successfully will be logged to the file /var/opt/acc/log/XXX.tlog,
where XXX represents the day of the week, for example, mon.tlog and
tue .tlog.
If any error is reported during the start up procedure, it may be
necessary to stop the ZCOM subsystem by running:
% zmasterd stop
The error should then be addressed, and then the ZCOM subsystem
should be restarted. Refer to the ACC Error Guide for detailed
information about messages reported by zmlog.