ACC SNAplus2 Link Software User's Guide

10 Chapter1
About ACC SNAPlus2 Link Software
Introduction
Introduction
The ACC SNAPlus2 Link Software product allows Hewlett-Packard’s
HP-UX SNAplus products to be used with SDLC over Multi-channel
ACC Multiplexer products. This manual provides installation and
configuration information that is specific to the SNA/ACC Software.
Refer to the ACC Error G uide for information about SNA/ACC error
codes.
The ACC SNAPlus2 Link Software product may be obtained for the
8-Channel HP-PB (NIO), the 8-Channel EISA, the 8-Channel PCI, and
the 2-Channel HP-PB (NIO) interfaces.
NOTE The ACC SNAPlus2 Link Software is needed when the SNAPlus2 Link is
to be used with SDLC via mult i-channel ACC. For SNA over X.25, only
the X.25/ACC (ACC and X.25/9000 Link Software) and SNAplus2
products are required.
When ACC SNAPlus2 Link Software is installed, the ACC interface
supports SNAplus2 running over SDLC, X25 or other protocols
simultaneously on the same ACC multiplexer card.