HP-UX Standard Mode Security Extensions Release Notes

HP-UX Standard Mode Security Extensions Release Note
Installing the HP-UX Standard Mode Security Extensions Software
Chapter 1 13
Installing the HP-UX Standard Mode Security Extensions
Software
The HP-UX Standard Mode Security Extensions software can be installed from Software
Depot or from the Software Pack CD-ROM.
Installing from Software Depot
Follow these instructions to download the software. This installation information is also at:
http://www.software.hp.com/portal/swdepot/displayInstallInfo.do?productNumber=StdModSe
cExt
Step 1. Go to HP Software Depot at http://www.software.hp.com.
Step 2. Search for Standard Mode Security Extensions and read the information on
that page.
Step 3. Select Receive for Free >> .
Step 4. Enter your registration information and accept the Terms and Conditions.
Step 5. Select Electronic Download and save the release depot as a local file on your
system. For example, save into
/tmp/StdModSecExt.depot
Step 6. Verify that the depot file is on your system using the following swlist command:
# swlist -s /tmp/StdModSecExt.depot
Step 7. Install the StdModSecExt bundle using the following swinstall command. Note
that the autoreboot flag must be specified. The system will reboot after
installation.
# swinstall -x autoreboot=true -s /tmp/StdModSecExt.depot \*
The swinstall command displays an error message if the installation fails. Check
the /var/opt/adm/sw/swagent.log for information if the installation failed.