HP-UX Standard Mode Security Extensions B.11.23.02 Release Notes

Availability in Native Languages
HP-UX Standard Mode Security Extensions is currently available in English only.
Installing the HP-UX Standard Mode Security Extensions Software
The HP-UX Standard Mode Security Extensions software can be installed from Software Depot
or from the Software Pack CD-ROM.
Installing from Software Depot
Follow these instructions to download the software. This installation information is also at:
http://www.software.hp.com/portal/swdepot/displayInstallInfo.do?productNumber=StdModSecExt
1. Go to HP Software Depot at http://www.software.hp.com.
2. Search for Standard Mode Security Extensionsand read the information on that
page.
3. Select Receive for Free >> .
4. Enter your registration information and accept the Terms and Conditions.
5. Select Electronic Download and save the release depot as a local file on your system.
For example, save into the following file:
/tmp/StdModSecExt.depot
6. Verify that the depot file is on your system using the following swlist command:
# swlist -s /tmp/StdModSecExt.depot
7. Install the StdModSecExt bundle using the following swinstall command. Note that the
autoreboot flag must be specified. The system will reboot after installation.
# swinstall -x autoreboot=true -s /tmp/StdModSecExt.depot \*
The swinstall command displays an error message if the installation fails. Check the
/var/opt/adm/sw/swagent.log for information if the installation failed.
NOTE: The name and location of the depot above are for example only. The actual name
and location may vary.
8. Verify the installation using the swlist command. If the StdModSecExt bundle is installed
on the system, the swlist command will report the following information. Note that within
the StdModSecExt bundle, the product name is: TrustedMigration which is the correct
product name.
# swlist -a state -a revision -l fileset TrustedMigration
# Initializing...
# Contacting target "mysystem"...
#
# Target: mysystem:/
# StdModSecExt B.11.23.02
StdModSecExt.TSMG-ENG-A-MAN B.11.23.02 configured
StdModSecExt.TSMIG-CONF B.11.23.02 configured
StdModSecExt.TSMIG-RUN B.11.23.02 configured
9. If there was not a reboot specified in Step 7, reboot manually.
10. Check for these changes:
• The file: /var/adm/userdb (user database) directory will be created and the
/etc/security.dsc file will be installed after the StdModSecExt bundle is installed.
• The /etc/pam.conf file will be modified. After installation, verify the contents of this
file. The previous version is saved in /etc/pam.conf.old. After an uninstall, the
/etc/pam.conf file will be restored.
Installing the HP-UX Standard Mode Security Extensions Software 13