HP-UX Security Attributes Configuration Release Notes HP-UX 11i v2 May 2005 update Manufacturing Part Number: 5991-1005 May 2005 United States © Copyright 2005 © Hewlett-Packard Development Company, L.P.
Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material.
1 HP-UX Security Attributes Configuration Release Notes Chapter 1 3
HP-UX Security Attributes Configuration Release Notes Announcement Announcement The HP-UX Security Attributes Configuration product is introduced in the HP-UX 11i v2 May 2005 update release to perform the following tasks without converting the HP-UX system to the trusted mode: • Configure system-wide values of security attributes from the System Defaults tab. The configurable system-wide values are stored in the /etc/security.dsc file.
HP-UX Security Attributes Configuration Release Notes What’s in This Version What’s in This Version Following are the new features in this release: • Simple method of to configure system-wide values and per-user values of security attributes of local users and NIS users. • Launchpoint from HP-UX System Administration Manager , HP Systems Insight Manager and HP System Management Homepage. You can also launch the tool by executing the secweb(1M) command.
HP-UX Security Attributes Configuration Release Notes Known Problems and Workarounds Known Problems and Workarounds There are no known problems and workarounds in this version of the product.
HP-UX Security Attributes Configuration Release Notes Compatibility Information and Installation Requirements Compatibility Information and Installation Requirements Software Requirements The system must have standard HP-UX 11i v2 September 2004 or later core products installed on it. After the system has been ignited with all other software and applied with all required patches, install the SecConfig bundle using swinstall command.
HP-UX Security Attributes Configuration Release Notes Installing the HP-UX Security Attributes Configuration Product Installing the HP-UX Security Attributes Configuration Product Install the HP-UX Security Attributes Configuration product (Bundle Name: SecConfig) from the OE CD-ROM (HP-UX.11.23.0505 OEUR Media).
HP-UX Security Attributes Configuration Release Notes Removing the HP-UX Security Attributes Configuration Product Removing the HP-UX Security Attributes Configuration Product To remove the HP-UX Security Attributes Configuration product from the HP-UX 11i v2 September 2004 (or later) system, login as root and use the swremove command. Use the swlist command to verify that the SecConfig product was removed. The swlist command will not list SecConfig if it was removed.
HP-UX Security Attributes Configuration Release Notes List of Documents available with the Product List of Documents available with the Product The HP-UX Security Attributes Configuration Release Notes is available with the product and is also available on http://docs.hp.com. Also, refer to the following related documents on http://docs.hp.com: • HP-UX Standard Mode Security Enhancement Release Notes • HP-UX Security Containment Release Notes The above HP-UX documentation is available from http://docs.
