HP-UX Reference (11i v3 07/02) - 5 Miscellaneous Topics (vol 9)

s
sd(5) sd(5)
Log Level Log Detail Information Included
No information is written to the
logfile.
loglevel=0
Only key events are logged; this is the
default.
loglevel=1 logdetail=false
Event detail as above plus task pro-
gress messages. Setting loglevel=1 is
not necessary, it is the default.
loglevel=1 logdetail=true
Event and file level messages only.
Setting the logdetail=false option is
not necessary.
loglevel=2 logdetail=false
All information is logged. Setting both
loglevel=2 and logdetail=true options
is required. This combination may
produce the same logfile behavior as
previous HP-UX 10.x releases.
loglevel=2 logdetail=true
Applies to swconfig, swcopy, swinstall, swreg, swremove, and swverify.
logfile=/var/adm/sw/sw<command>.log
Defines the default log file for each SD command. (The agent log files are always located
relative to the target depot or target root, e.g. /var/spool/sw/swagent.log
and
/var/adm/sw/swagent.log
.)
Applies to all commands except
swacl, swlist, and swjob.
loglevel=1
Controls the log level for the events logged to the command logfile, the target agent logfile,
and the source agent logfile by prepending identification numbers to SD logfile messages.
This information is in addition to the detail controlled by the logdetail option. See
logdetail for more information.
A value of:
0 provides no information to the log files.
1 enables verbose logging to the log files.
2 enables very verbose logging to the log files.
Applies to swconfig, swcopy, swinstall , swmodify, swpackage, swremove,
and swverify.
match_target=false
If set to true, software selection is done by locating filesets on the source that match the
target system’s installed filesets. If multiple targets are specified, the first in the list is
used as the basis for selections.
Applies to swinstall.
max_agents=-1
The maximum number of agents that are permitted to run simultaneously. The value of -1
means that there is no limit.
Applies to swagentd.
max_targets=25
When set to a positive integer, this option limits the number of concurrent install or copy
operations to the number specified. As each copy or install operation completes, another
target is selected and started until all targets are completed.
Server and network performance determines the optimal setting; a recommended starting
point is 25 (the default value). If you set this option to a value of less than one, SD
attempts to install or copy to all targets at once.
Applies to swcopy and swinstall.
media_capacity=1330
If creating a distribution tape or multiple-directory media such as a CD-ROM, this keyword
specifies the capacity of the tape in one million byte units (not Mbytes). This option is
HP-UX 11i Version 3: February 2007 − 19 − Hewlett-Packard Company 439