HP-UX Reference (11i v3 07/02) - 5 Miscellaneous Topics (vol 9)
s
sd(5) sd(5)
the subproducts in the product) with a create_time less than or equal to the specified value
are available for selection (or autoselection). To list the create_time of bundles, products
and filesets, use:
swlist -a create_time -a create_date
Applies to swlist, swcopy, and
swinstall.
customer_id=
This number, printed on the Software Certificate, "unlocks" protected software and restricts
installation to a specific site or owner. You can enter the number with the
-x
customer_id= option or by using the Interactive User Interface. The customer_id can be
used on any HP-UX 10.X or later system.
Applies to
swinstall, swcopy, swlist.
defer_configure=false
Causes swinstall to automatically run configure scripts for the software_selections after
they are installed. (Alternate root directories are not configured.)
When set to true,
swinstall does not run configure scripts. If you want to configure the
software later, you must run the swconfig command.
NOTES:
• Multiple versions of a product will not be automatically configured if another version is
already configured. Use the swconfig command to configure multiple versions
separately.
• SD ignores this option when it installs software that causes a system reboot.
Applies to swinstall.
distribution_source_directory=/var/spool/sw
Defines the default location of the source depot (when the source_type is directory).
You can also use the host
:path syntax. The -s option overrides this default.
Applies to swcopy, swinstall, and swpackage .
distribution_target_directory=/var/spool/sw
Defines the default distribution directory of the target depot. The target_selection operand
overrides this default.
Applies to
swacl, swcopy, swlist, swmodify, swpackage , swreg, swremove,
and
swverify.
distribution_target_serial=/dev/rmt/0m
Defines the default location of the target tape device file. The target_selection operand
overrides this default.
Applies to
swpackage.
enforce_dependencies=true
Requires that all dependencies specified by the software_selections be resolved either in the
specified source, or at the target_selections themselves.
The
swconfig, swcopy, and swinstall commands will not proceed unless the depen-
dencies have also been selected or already exist at the target in the correct state
(INSTALLED, CONFIGURED, or AVAILABLE). This prevents unusable software from
being installed on the system. It also ensures that depots contain usable sets of software.
For swremove, if a selected fileset has dependents (i.e. other software depends on the
fileset) and they are not selected, do not remove the selected filesets.
If set to false, dependencies are checked, but not enforced. Corequisite dependencies, if
not enforced, may keep the selected software from working properly. Prerequisite or exre-
quisite dependencies, if not enforced, may cause the installation or configuration to fail.
Applies to swconfig, swcopy, swinstall, swremove , and swverify.
enforce_dsa=true
Prevents a command from proceeding past the analysis phase if the disk space required is
beyond the available free space of the impacted file systems. If set to false, then the
434 Hewlett-Packard Company − 14 − HP-UX 11i Version 3: February 2007