HP-UX Reference (11i v3 07/02) - 4 File Formats (vol 8)

r
ramd.conf(4) ramd.conf(4)
[metric metricvalue [level (l1
|l2|both)];]
[
passive (on|off);
]
[
priority prioritylevel [
level (l1|l2 |both)]
;
[extdomain (true|false);
]};
where:
enable|disable ;
Enables or disables isisd. By default, this value is
disable.
smallhellos (on|off);
Specifies to send unpadded hellos on the interface. By default, this value is
off.
auth (simple... | none
);
Specifies the authentication type and authentication key for the interface. By default, this value is
none.
csn-interval time-interval [
level (l1|l2|both)];
Specifies the CSNP interval time for an interface. By default, this value is 10 seconds.
psn-interval time-interval [level (
l1|l2|both)];
Specifies the PSNP interval time for an interface. By default, this value is 2 seconds.
dis-hello-interval
time-interval [level (l1|l2|both)];
Specifies the Designate IS (DIS) hello interval time for an interface. By default, this value is 1000
milliseconds.
hello-interval time-interval [
level (l1|l2|both)];
Specifies the interval time for IS-IS to advertise hello packets on the interface. By default, this
value is 3 seconds.
hello-multiplier multipliernum [
level (l1|l2|both)];
Specifies the number of hello intervals between reception of a hello before considering the neighbor IS
as down. By default, this value is 10 seconds.
lsp-interval time-interval;
Specifies the minimum time to wait before regenerating LSP. By default, this value is 5 seconds.
level (l1|l2|both);
Specifies the level of the interface. By default, this value is same as system level.
metric metricvalue [level (l1|l2|both)];
Specifies the metric for traversing an interface. By default, the metric value is 10.
passive (on|off);
Specifies the interface as passive. That is, IS-IS is off and the ifaddress is sent out in LSPs to
other interfaces. By default, this value is
off.
priority prioritylevel [level (
l1|l2|both)];
Specifies the priority of DIS election for an interface. By default, the priority level is 64.
extdomain (true|false);
Specifies the external domain attribute of an interface. By default, this value is false
.
System ID for IS-IS
This configuration is used to specify the system ID of the router. This configuration is mandatory.
systemid systemid;
where systemid specifies the system ID of the router.
Overload for IS-IS
The following configuration specifies whether the IS-IS system enters or leaves overload state. By default,
this value is off.
The syntax of the overload configuration statement is as follows:
overload (off|l1|l2|both);
where:
off Specifies that isisd does not enter the overload state.
HP-UX 11i Version 3: February 2007 − 23 − Hewlett-Packard Company 361