HP-UX Reference (11i v3 07/02) - 1M System Administration Commands N-Z (vol 4)

nwmgr_btlan(1M) nwmgr_btlan(1M)

Command To Reset Statistics of a NIC

lanadmin nwmgr

lanadmin -c PPA nwmgr -r -st -c lan PPA

Command To Reset MTU To the Default Value

lanadmin nwmgr

lanadmin -R PPA nwmgr -s -A mtu

-from default -c lan PPA

Command To Set To Default Conﬁgurations

lanadmin nwmgr

lanadmin -A DEFAULT PPA nwmgr -s -A mac

-from default -c lan PPA

NOTE: Similarly default configuration

can be set for the other attributes

like speed,mtu, mac etc.

Note: The nwmgr equivalent for displaying the usage information is not available.

Note: The lanadmin options that support apa and vlan are covered in the nwmgr_apa(1M) and

nwmgr_vlan(1M) manpages.

COMPARISON WITH LINKLOOP COMMAND

Command to Test the Link Level Connectivity

linkloop nwmgr

linkloop -i PPA nwmgr -diag -A dest=MAC_Address

MAC_Address -c lanPPA

linkloop -i PPA nwmgr --diag -A dest=linkaddr,

-n count -s size pktsize=size, timeout=timeout

-t timeout MAC_Address --it count -c lanPPA

linkloop -r rif N/A

Note: nwmgr does not allow multiple station addresses to be speciﬁed in the same command line.

COMPARISON WITH LANSCAN COMMAND

Command To List Interfaces and Their Attributes

lanscan nwmgr

lanscan nwmgr -g -v -c lan PPA

nwmgr -C lan

nwmgr -S gelan

Command To Display Interface Names Only

lanscan nwmgr

lanscan -i nwmgr -g -v -c lan PPA

nwmgr -C lan -sc | awk -F# ’/if_state/ {print $1}’

96 Hewlett-Packard Company − 7 − HP-UX 11i Version 3: February 2007