HP-UX Reference (11i v3 07/02) - 1M System Administration Commands N-Z (vol 4)

p
parmodify(1M) parmodify(1M)
For more information about actions that are restricted on iCAP partitions, refer to the HP Instant Capacity
User’s Guide located at
http://docs.hp.com
.
DEPENDENCIES
This command uses the Web-Based Enterprise Management (WBEM) product and some of its configuration
settings. If you encounter connection errors when using the
-u option, check that the following two condi-
tions are satisfied:
• Use the
cimconfig command (see cimconfig(1M) in the WBEM product documentation) to verify (and
correct if necessary) the setting of the following two variables:
•
enableRemotePrivilegedUserAccess=true
• enableHttpsConnection=true
• The target partition’s digital certificate has been appended to the local partition’s Shared Authentication
Store. For the nPartition commands, the Shared Authentication Store is stored in the file:
/etc/opt/hp/sslshare/known_hosts.pem
. This file is used by all the clients, which use SSL
based certificates. If these clients trust a target partition, then the nPartition commands will also trust
the target partition.
Refer to the WBEM documents specified in the SEE ALSO section below for further information.
AUTHOR
parmodify was developed by the Hewlett-Packard Company.
SEE ALSO
fruled(1), parstatus(1), cplxmodify(1M), frupower(1M), parcreate(1M), parmgr(1M), parremove(1M),
parunlock(1M), partition(5).
nPartition Administrator’s Guide on
http://docs.hp.com,
HP WBEM Services for HP-UX System Administrator’s Guide on
http://docs.hp.com,
HP WBEM Services for HP-UX 11i v2.0 on Integrity Servers Version A.01.05 Release Notes on
http://docs.hp.com
.
HP-UX 11i Version 3: February 2007 − 5 − Hewlett-Packard Company 137