HP-UX Reference (11i v3 07/02) - 1M System Administration Commands N-Z (vol 4)

ManualsBrandsHP ManualsSoftwareHP-UX Reference Manuals

131

132

133

134

135

136

137

138

139

140

parcreate(1M) parcreate(1M)

command displays the above cell as "cab1,cell4". See parstatus(1).

RETURN VALUE

The

parcreate command exits with one of the following values:

0 Successful completion.

1 Error condition occurred.

EXAMPLES

Create a new partition myPartition with two cells. One of the cells is located in cabinet 0, slot 4. The

celltype for the cell is base. The failure_usage policy for this cell is

ri. The CLM value for this cell is 1

GB.

The other cell is located in cabinet 0, slot 6. The celltype and failure_usage are not speciﬁed for this cell.

The use_on_next_boot for both cells is

parcreate -P myPartition -c 0/4:base:y:ri:1GB

-c 6::y: -b 0/0/1/2.6 -t 0/0/1/3.6

-s 0/0/1/4.6 -r 0/4

Create a new partition nextPartition

with two cells. The cells are located in cabinet 0, slot 0 and slot

1. This example uses the default values for the cells. The default celltype will be

base

The default failure_usage policy will be

ri. The default use_on_next_boot will be y. By default there will

be no CLM for the cells.

parcreate -P nextPartition -c 0::: -c 0/1:::

WARNINGS

Activation of Instant Capacity (iCAP) components (cells and CPUs) is possible with the parcreate com-

mand. This may result in the requirement to purchase such components to stay in compliance with a

customer’s iCAP contract.

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and some of its conﬁguration

settings. If you encounter connection errors when using the

-u option, check that the following two condi-

tions are satisﬁed:

• Use the cimconfig command (see cimconﬁg(1M) in the WBEM product documentation) to verify (and

correct if necessary) the setting of the following two variables:

• enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• The target partition’s digital certiﬁcate has been appended to the local partition’s Shared Authentication

Store. For the nPartition commands, the Shared Authentication Store is stored in the ﬁle:

/etc/opt/hp/sslshare/known_hosts.pem

. This ﬁle is used by all the clients, which use SSL

based certiﬁcates. If these clients trust a target partition, then the nPartition commands will also trust

the target partition.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

parcreate was developed by the Hewlett-Packard Company.