HP-UX Reference (11i v3 07/02) - 1M System Administration Commands N-Z (vol 4)

n
nwmgr_vlan(1M) nwmgr_vlan(1M)
The valid range is 0-7.
The default is 0.
pri_override=
level Priority override provides a mechanism to convert IP level precedence (IPV4 ToS
octet) to link level 802.1p user priority.
Priority override applies to outbound frames only. Priority override level strings
are:
CONF_PRI Your specified priority value will be used. This is the default
value.
IP_HEADER IP header ToS will be converted to 802.1p priority.
CONF_TOS Your specified ToS value will be converted to 802.1 priority.
speed Speed and duplex of the related interface. For 10 Mbps, 100 Mbps, and multiple
of 10 and 100 Mbps, the speed is displayed in Mbps. For 1 Gbps and above, the
speed is displayed in Gbps. The duplexity can be either "half" or "full".
Only valid for the get operation.
timeout=seconds Specifies how many seconds to wait for acknowledgement of each test frame for
the diagnose operation.
The default is 5 seconds.
tos=ToS_value Specifies the IP precedence in the IP header. Switches ignore ToS. Routers may
use it.
The valid range is 0-255.
The default is 0.
tos_override=level ToS override provides a mechanism to override the IP level precedence in the
header of an inbound IP packet. ToS override level strings are:
IP_HEADER ToS value in the IP header will be used. This is the default
value.
ETHER_HEADER Ether header 802.1p priority will be converted to a ToS value.
CONF_TOS Your specified ToS value will be used.
CONF_PRI Your specified 802.1 priority value will be converted to a ToS
value.
vlanid=vlanid Uniquely identifies the VLAN to which a frame belongs.
USAGE
The common usages of nwmgr for VLAN interfaces are described in this section.
Add a VLAN Interface
nwmgr -a -S vlan [-c lanVPPA] -A vlanid=vlanid, ppa=PPA [,attr=value...] [--sc]
nwmgr --add --subsystem vlan [--class_instance lanVPPA]
-A vlanid=vlanid, ppa=PPA [,attr=value...] [--sc]
This command adds a VLAN interface over a VLAN capable interface. If a VPPA (virtual PPA) is
specified as a target with the -c option, the VLAN interface added will be allocated that VPPA. If the
-c option is not specified, the VPPA is allocated by the system.
The valid attributes (specified with the -A option) for the add operation are:
ppa=PPA
vlanid=vlanid
pri=priority
tos=ToS_value
name=name
tos_override= level
pri_override= level
108 Hewlett-Packard Company − 3 − HP-UX 11i Version 3: February 2007