HP-UX Reference (11i v3 07/02) - 1M System Administration Commands A-M (vol 3)

m
mksf(1M) mksf(1M)
-e Eject page after paper-out recovery.
-n No form-feed.
-o Old paper-out behavior (abort job).
-r Raw.
-t Transparent mode (normally used by diagnostics).
-w No wait. Don’t retry errors on open.
special-file The default special file name depends on whether the
-r option is used:
-r Special File Name
no ccardttargetddevice_lp
yes ccardttargetddevice_rlp
mux0 mux2 mux4 pci_mux0 pci_mux1
-a
access-mode
Port access mode (0-2). The default access mode is 0 (Direct connect). The
access-mode meanings are:
access-mode Port Operation
0 Direct connect
1 Dial out modem
2 Dial in modem
-c CCITT.
-f Hardware flow control (RTS/CTS).
-i Modem dialer. Cannot be used with -l.
-l Line printer. Cannot be used with -i.
-p port Multiplexer port number (0-15 for mux0 and mux2; 0
-1 for mux4; a1-a16, b1-
b16, c1-c16, and so on, for the pci_mux0 or pci_mux1). Some MUX cards con-
trolled by a particular driver have fewer than the maximum supported ports.
-t Transparent mode (normally used by diagnostics).
special-file The default special file name depends on the access-mode and whether the
-i and -l
options are used. The term "card" below refers to the Instance number of the mux
card.
access-mode -i -l Special File Name
—noyesccardpport_lp
2 no no ttydcardpport
1 no no culcardpport
0 yes no cuacardpport
0 no no ttycardpport
ps2
Note that only one of -a,or-p is allowed.
-a auto_device
Autosearch device. An auto_device value of 0 means first mouse; a value of 1 means
first keyboard.
-p port PS2 port number.
special-file The default special file name depends on the -a, and -p options:
520 Hewlett-Packard Company − 6 − HP-UX 11i Version 3: February 2007