HP-UX Reference (11i v3 07/02) - 1M System Administration Commands A-M (vol 3)

m
mksf(1M) mksf(1M)
fifo-trigger Receive FIFO Trigger Level
0 1
1 4
2 8
3 14
-t Transparent mode (normally used by diagnostics).
-x xmit-limit xmit-limit should have a value between 0 and 3. The following table shows the
corresponding transmit limit for a given xmit-limit value.
xmit-limit Transmit Limit
0 1
1 4
2 8
3 12
special-file The default special file name is as follows:
Special File Name
ttycardp0
disc3
-f
Floppy.
-r Raw; create character, not block, special file.
-s section The section number.
special-file The default special file name depends on whether the -r and -s
options are used:
-r -s Special File Name
yes no rdsk/ccardttargetddevice and
rfloppy/ccardttargetddevice
yes yes rdsk/ccardttargetddevicessection
no no dsk/ccardttargetddevice and
floppy/ccardttargetddevice
no yes dsk/ccardttargetddevicessection
esctl
-r
Raw; create character, not block, special file.
special-file The default special file name is pt/pt_ctlinstance
.
eschgr
-r
Raw; create character, not block, special file.
-P Create a pass through special file.
special-file The default special file name is rchgr/autochinstance
.
The default pass through special file name for autochanger is
pt/pt_autochinstance.
esdisk
-r
Raw; create character, not block, special file.
-s section The section number.
-P Create a pass through special file.
special-file The default special file name depends on whether the -r and -s options are used:
518 Hewlett-Packard Company − 4 − HP-UX 11i Version 3: February 2007