HP-UX Reference (11i v3 07/02) - 1M System Administration Commands A-M (vol 3)

ManualsBrandsHP ManualsSoftwareHP-UX Reference Manuals

231

232

233

234

235

236

237

238

239

240

frupower(1M) frupower(1M)

Note: This command is a Web-Based Enterprise Management (WBEM) Client Applica-

tion. The -u option accesses the target partition using a Secure Sockets Layer (SSL)

connection. If errors are reported, check that the conditions described in the DEPEN-

DENCIES section are satisﬁed.

Mapping of Global Cell Numbers to Local Cell Numbers

The cabinets in a complex are numbered starting from 0. The cell slots in each cabinet are also numbered

starting from 0. Each cabinet can have a maximum of 8 cells. For example, the cells located in cabinet 0

will have the following cell numbers in global format: 0, 1, 2, 3, 4, 5, 6, 7. The cell numbers in correspond-

ing local format will be 0/0, 0/1, 0/2, 0/3, 0/4, 0/5, 0/6, 0/7.

Similarly the cells located in cabinet 1 will have the following cell numbers in global format: 8, 9, 10, 11, 12,

13, 14, 15. The cell numbers in corresponding local format will be 1/0, 1/1, 1/2, 1/3, 1/4, 1/5, 1/6, 1/7.

From the above convention the cell located in cabinet 1, slot 0 is identiﬁed in the local format as 1/0 or in

the global format as 8. The

parstatus command will display the above cell as "cab1,cell0". The cell

located in cabinet 1, slot 4 is identiﬁed in the local format as 1/4 or in the global format as 12. The

par-

status

command will display the above cell as "cab1,cell4". See parstatus(1).

RETURN VALUE

The

frupower command exits with one of the following values:

0 Successful completion.

1 Error condition occurred.

EXAMPLES

Power on the cell located in cabinet 0 slot 4 of a partition identiﬁed by the hostname GreenRiver:

frupower -o -c 0/4 -u RemoteAdmin: -h GreenRiver

RemoteAdmin must have superuser permissions on GreenRiver. The command prompts for the password.

Power off two cells located in cabinet 0 slot 4 and cabinet 0 slot 6.

frupower -f -c 0/4 -c 0/6

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and some of its conﬁguration

settings. If you encounter connection errors when using the

-u option, check that the following two condi-

tions are satisﬁed:

• Use the cimconfig command (see cimconﬁg(1M) in the WBEM product documentation) to verify (and

correct if necessary) the setting of the following two variables:

• enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• The target partition’s digital certiﬁcate has been appended to the local partition’s Shared Authentication

Store. For the nPartition commands, the Shared Authentication Store is stored in the ﬁle:

/etc/opt/hp/sslshare/known_hosts.pem

. This ﬁle is used by all the clients, which use SSL

based certiﬁcates. If these clients trust a target partition, then the nPartition commands will also trust

the target partition.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

frupower was developed by the Hewlett-Packard Company.