HP-UX Reference (11i v3 07/02) - 1M System Administration Commands A-M (vol 3)

cplxmodify(1M) cplxmodify(1M)

Note: This command is a Web-Based Enterprise Management (WBEM) Client Applica-

tion. The -u option accesses the target partition using a Secure Sockets Layer (SSL)

connection. If errors are reported, check that the conditions described in the DEPEN-

DENCIES section are satisﬁed.

RETURN VALUE

The

cplxmodify command exits with one of the following values:

0 Successful completion.

1 Error condition occurred.

EXAMPLES

Change the name of the local complex to "Basingstoke".

cplxmodify -N Basingstoke

Change the name of a remote complex to "Ploverleigh". The command prompts for the password.

cplxmodify -N Ploverleigh -g -h RemoteComplex

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and some of its conﬁguration

settings. If you encounter connection errors when using the

-u option, check that the following two condi-

tions are satisﬁed:

• Use the cimconfig command (see cimconﬁg(1M) in the WBEM product documentation) to verify (and

correct if necessary) the setting of the following two variables:

• enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• The target partition’s digital certiﬁcate has been appended to the local partition’s Shared Authentication

Store. For the nPartition commands, the Shared Authentication Store is stored in the ﬁle:

/etc/opt/hp/sslshare/known_hosts.pem

. This ﬁle is used by all the clients, which use SSL

based certiﬁcates. If these clients trust a target partition, then the nPartition commands will also trust

the target partition.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

cplxmodify was developed by the Hewlett-Packard Company.