HP-UX Reference (11i v3 07/02) - 1 User Commands N-Z (vol 2)
p
parstatus(1) parstatus(1)
slot 1 is locally identified as 0/1 or globally as 1.
-g Allows access to the complex specified by the
-h option. The accessed complex is then
considered the target complex. Access is through the service processor’s LAN port.
The
-h option is required if this option is used.
If this option is specified, the command prompts for the password.
If an error is reported when you attempt to connect using this option, check to see that
IPMI LAN access has not been disabled on the remote service processor. Access to the
complex through IPMI over LAN can be enabled or disabled by logging on to the service
processor and using the SA command from the Command Menu.
The -u and -g options are mutually exclusive.
-h IPaddress|hostname
This option should only be used in combination with either the
-u or -g option.
IPaddress|hostname specifies the IP address or hostname of the target partition (
-u
)or
complex (
-g).
-I Show information for all I/O chassis in the complex.
-i I/Ochassis Show information about the specified I/Ochassis. The I/Ochassis id can be specified in
the form of cabinet#/enclosure#/chassis#. For example, the I/O chassis located in
cabinet 0, enclosure 1 and I/O chassis slot 3 is identified as 0/1/3.
-M Produce a machine readable/parseable output, or restrict the output of the
-w option to
a partition number. The machine readable output will have the columns separated by a
single colon character (
:) and will not have a column header.
-P Show information for all partitions in the complex.
-p PartitionNumber
Show information about the specified partition. PartitionNumber is the unique partition
number (integer) which was assigned to the partition when it was created.
-s Indicates if the command is being executed on a hardware partitionable platform. When
this option is specified, the command will either succeed or fail (see RETURN VALUE
below) and nothing will be displayed on stdout or stderr.
-T Only display the Hyper-Threading information for supported systems. If the
-T option
is used with other options, an error occurs except when the
-T option is used with its
related options. If the -T option is used on a non-supported system, an error occurs.
-u username[:] Specifies the required authorization to access a partition other than the local partition
(but can also be used as a loopback access to the local partition). If complex attributes
are displayed, the complex is the one in which this target partition resides.
The -h option is required if this option is used.
If this option is specified, the command prompts for the password.
username specifies a configured user name on the target partition.
Note: This command is a Web-Based Enterprise Management (WBEM) Client Applica-
tion. The -u option accesses the target partition using a Secure Sockets Layer (SSL)
connection. If errors are reported, check that the conditions described in the DEPEN-
DENCIES section are satisfied.
-V Verbose mode. Increase the amount of information displayed. Additional information
displayed with -V includes:
For Cabinet:
* Status of each of the cabinet blower(s)
* Status of each of the I/O fan(s)
* Status of each of the bulk power supply(s)
* Status of each of the backplane power board(s)
For Partition:
* Primary, alternate and secondary boot path settings
* PDC, IODC version numbers
84 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: February 2007