HP-UX Reference (11i v2 07/12) - 5 Miscellaneous (vol 9)

s
sd(5) sd(5)
cannot be rolled back (removed) unless the base software modified by the patch is removed
at the same time.
Applies to swinstall.
polling_interval=2
Defines in seconds the polling interval used by interactive (GUI) sessions. It specifies how
often each target agent will be polled to obtain status information about the task being per-
formed. When operating across wide-area networks, the polling interval can be increased
to reduce network overhead.
Applies to swcopy, swinstall, and
swremove.
preserve_create_time=false
Preserves the original create time when you copy depots, which produces consistent results
when you use the copies. The default of
false sets the create_time of software bundles,
products, and filesets equal to the time the object was created in the depot. When set to
true, the create_time of software bundles, products, and filesets is set to that specified in
the source depot. Note that using this option when copying to a master depot can change
the objects that are visible when you use the create_time_filter
option.
Applies to
swcopy.
reboot_cmd=/sbin/reboot
Defines the command called by the agent to reboot the system.
Applies to
swagent.
reconfigure=false
Prevents software which is already in the CONFIGURED state from being reconfigured. If
set to true, CONFIGURED software can be reconfigured.
Applies to swconfig.
recopy=false
This option prevents SD from recopying (overwriting) an existing revision of a fileset. If set
to true, the fileset will be recopied.
Applies to swcopy.
register_new_depot=true
Causes swcopy to register a newly created depot with the local swagentd. This action
allows other SD commands to automatically "see" this depot. If set to
false, a new depot
will not be automatically registered. (It can be registered later with the
swreg com-
mand.)
Applies to
swcopy.
register_new_root=true
Causes swinstall to register a newly created alternate root with the local swagentd.
This action allows other SD commands to automatically "see" this root. If set to
false,a
new root will not be automatically registered. (It can be registered later with the
swreg
command.)
Applies to swinstall.
reinstall=false
This option prevents SD from re-installing (overwriting) an existing revision of a fileset. If
set to
true, the fileset will be overwritten.
Applies to swinstall.
reinstall_files=false
Controls the overwriting of files, which may enhance performance on slow networks or
disks. At the default value of false, SD compares each file in a source fileset to correspond-
ing files on the target system. SD compares the files based on size, timestamp, and (option-
ally) the checksum (see reinstall_files_use_cksum ). If the files are identical the
files on the target system are not overwritten.
When set to true, SD does not compare files and overwrites any identical files on the target.
HP-UX 11i Version 2: December 2007 Update − 21 − Hewlett-Packard Company 391