HP-UX Reference (11i v2 07/12) - 5 Miscellaneous (vol 9)

s
sd(5) sd(5)
logdetail for more information.
A value of:
0 provides no information to the log files.
1 enables verbose logging to the log files.
2 enables very verbose logging to the log files.
Applies to swconfig, swcopy, swinstall
, swmodify, swpackage, swremove,
and
swverify.
match_target=false
If set to true, software selection is done by locating filesets on the source that match the
target system’s installed filesets. If multiple targets are specified, the first in the list is
used as the basis for selections.
Applies to swinstall.
max_agents=-1
The maximum number of agents that are permitted to run simultaneously. The value of -1
means that there is no limit.
Applies to swagentd.
max_targets=25
When set to a positive integer, this option limits the number of concurrent install or copy
operations to the number specified. As each copy or install operation completes, another
target is selected and started until all targets are completed.
Server and network performance determines the optimal setting; a recommended starting
point is 25 (the default value). If you set this option to a value of less than one, SD
attempts to install or copy to all targets at once.
Applies to swcopy and swinstall.
media_capacity=1330
If creating a distribution tape or multiple-directory media such as a CD-ROM, this keyword
specifies the capacity of the tape in one million byte units (not Mbytes). This option is
required if the media is not a DDS tape or a disk file. Without this option,
swpackage
sets the size to the default of 1,330 Mbytes for tape or to the amount of free space on the
disk up to minfree for a disk file. SD uses the same format across multiple directory
media as it does for multiple serial media, including calculations of the correct size based
partitioning of filesets and setting of the media_sequence_number
attributes.
Applies to
swpackage.
media_type=directory
Defines the type of distribution to create. The recognized types are directory and
tape.
Applies to swpackage.
minimum_job_polling_interval=1
Defines in minutes how often the daemon wakes up to scan the job queue for scheduled jobs
that must start. If set to 0, no scheduled jobs are initiated.
Applies to swagentd.
mount_all_filesystems=true
By default, the SD commands attempt to mount all filesystems in the /etc/fstab file at
the beginning of the analysis phase, to ensure that all listed filesystems are mounted before
proceeding. This policy helps to ensure that files are not loaded into a directory that may
be below a future mount point, and that the expected files are available for a remove or ver-
ify operation.
If set to false, the mount operation is not attempted, and no check of the current mounts
is performed.
Applies to swconfig, swcopy, swinstall, swremove , and swverify.
mount_cmd=/sbin/mount
Defines the command called by the agent to mount all filesystems.
HP-UX 11i Version 2: December 2007 Update − 19 − Hewlett-Packard Company 389