HP-UX Reference (11i v2 07/12) - 1M System Administration Commands N-Z (vol 4)

ManualsBrandsHP ManualsSoftwareHP-UX Reference Manuals

531

532

533

534

535

536

537

538

539

540

swverify(1M) swverify(1M)

mount_all_filesystems=true

By default, the SD commands attempt to mount all ﬁlesystems in the

/etc/fstab ﬁle at

the beginning of the analysis phase, to ensure that all listed ﬁlesystems are mounted before

proceeding. This policy helps to ensure that ﬁles are not loaded into a directory that may

be below a future mount point, and that the expected ﬁles are available for a remove or ver-

ify operation.

If set to

false, the mount operation is not attempted, and no check of the current mounts

is performed.

rpc_binding_info=ncacn_ip_tcp:[2121] ncadg_ip_udp:[2121]

Deﬁnes the protocol sequence(s) and endpoint(s) on which the daemon listens and which the

other commands use to contact the daemon. If the connection fails for one protocol

sequence, the next is attempted. SD supports both the tcp (

ncacn_ip_tcp:[2121]

)

and udp (

ncadg_ip_udp:[2121]

) protocol sequence on most platforms. See the sd(5)

man page by typing

man 5 sd for more information.

rpc_timeout=5

Relative length of the communications timeout. This is a value in the range from 0 to 9 and

is interpreted by the DCE RPC. Higher values mean longer times; you may need a higher

value for a slow or busy network. Lower values will give faster recognition on attempts to

contact hosts that are not up, or are not running

swagentd. Each value is approximately

twice as long as the preceding value. A value of 5 is about 30 seconds for the

ncadg_ip_udp protocol sequence. This option may not have any noticeable impact when

using the ncacn_ip_tcp protocol sequence.

run_as_superuser=true

This option controls SD’s nonprivileged mode. This option is ignored (treated as true) when

the invoking user is super-user.

When set to the default value of true, SD operations are performed normally, with permis-

sions for operations either granted to a local super-user or set by SD ACLs. (See swacl(1M)

for details on ACLs.)

When set to false and the invoking user is local and is not super-user, nonprivileged mode

is invoked:

• Permissions for operations are based on the user’s ﬁle system permissions.

• SD ACLs are ignored.

• Files created by SD have the uid and gid of the invoking user, and the mode of created

ﬁles is set according to the invoking user’s umask.

SD’s nonprivileged mode is intended only for managing applications that are specially

designed and packaged. This mode cannot be used to manage the HP-UX operating system

or patches to it. For a full explanation of nonprivileged SD, see the Software Distributor

Administration Guide, available at the

http://docs.hp.com web site.