HP-UX Reference (11i v2 07/12) - 1M System Administration Commands N-Z (vol 4)

s
setboot(1M) setboot(1M)
Primary bootpath : 2/0/1.6.0
HA Alternate bootpath : 2/0/1.6.1
Alternate bootpath : 2/0/2.0.0
Autoboot is ON (enabled)
Autosearch is ON (enabled)
SpeedyBoot
1. Display all current stable storage values.
setboot -v
on PA-RISC architecture displays:
Primary bootpath : 10/0.0.0
HA Alternate bootpath : 10/0/1.6.1
Alternate bootpath : 10/12/5.0.0
Autoboot is ON (enabled)
Autosearch is OFF (disabled)
TEST CURRENT SUPPORTED DEFAULT NEXT BOOT
---- ------- --------- ------- ---------
all partial partial partial partial
SELFTESTS partial yes on partial
early_cpu off yes on off
late_cpu on yes on on
FASTBOOT partial yes on partial
full_memory off yes on off
PDH on yes on on
CEC off no off off
on Itanium-based architecture displays:
Primary bootpath : 10/0.0.0
HA Alternate bootpath : 10/0/1.6.1
Alternate bootpath : 10/12/5.0.0
Autoboot is ON (enabled)
TEST CURRENT DEFAULT
---- ------- -------
all partial partial
SELFTESTS off on
early_cpu off on
late_cpu off on
FASTBOOT on on
Platform on on
Full_memory on on
Memory_init on on
IO_HW off off
Chipset on on
2. Enable full_memory and PDH tests and have those tests executed on all subsequent reboots.
setboot -t FASTBOOT=on
3. Disable the late processor tests and have those tests skipped on all subsequent reboots. If early CPU
tests are on when this command is executed, the SELFTESTS state in BCH stays on while set-
boot -v
shows it as partial.
setboot -t late_cpu=off
4. Reset all tests to the machine-shipped default values.
setboot -t all=default
328 Hewlett-Packard Company − 5 − HP-UX 11i Version 2: December 2007 Update