HP-UX Reference (11i v2 07/12) - 1M System Administration Commands N-Z (vol 4)

s
sasmgr(1M) sasmgr(1M)
enable
Enables the SAS I/O card / HBA and brings it back online. This command causes the driver to
initialize the SAS I/O card / HBA.
get_info
When the get_info command is run without qualifiers, it returns information about the SAS
I/O card / HBA represented by device_file.
The following qualifiers are specified with the
get_info command:
lun Shows hardware path and SAS address information for a specific lun or all luns.
lun_locate
Shows lun location information for the lun specified with the
lun qualifier.
pci_id
Shows PCI ID information for the SAS I/O card / HBA.
phy Shows information about all PHYs or a specific PHY.
phy_in_port
Shows information about a port to which the specified PHY belongs or provides information
about all ports.
raid
Shows RAID configuration information for the Core I/O card / HBA.
reg Displays the contents of a specific PCI config space or MMIO register or all PCI config
spaces or MMIO registers. PCI config space or MMIO register type is specified with the
reg_type qualifier. If reg_type is not specified, then the command assumes a default
register type of MMIO.
smp Issues a SMP command. The file_name must contain the SMP request frame.
smp_addr
Shows the SMP initiator SAS address to send SMP requests.
target
Shows information about a specific target or all targets.
vpd Shows vital product data information for the SAS I/O card / HBA.
get_stat
When the get_stat command is run without qualifiers, it shows statistics about the SAS I/O
card / HBA represented by device_file.
The following qualifiers are specified with the get_stat command:
phy Shows statistics for all PHYs or a specific PHY.
phy_in_port
Shows statistics for a port to which the specified PHY belongs to or provides statistics for
all ports.
target
Shows statistics for a specific target or all targets.
replace_tgt
The following qualifiers must be specified with the replace_tgt command:
old_dev
new_tgt_hwpath
Allows the lun_dsf specified with old_dev to be associated with a new SAS target which
is specified with the new_tgt_hwpath qualifier.
If the -f option is not specified, sasmgr displays a warning message before proceeding.
Otherwise, it suppresses the warning message and executes the command.
reset
Resets the SAS I/O card / HBA and performs a complete re-initialization. This is a destructive
operation. Some I/Os can be aborted by this command.
If the -f option is not specified with this command, sasmgr displays a warning message before
continuing. Otherwise, it suppresses the warning message and executes the command.
HP-UX 11i Version 2: December 2007 Update − 4 − Hewlett-Packard Company 293