HP-UX Reference (11i v2 07/12) - 1M System Administration Commands N-Z (vol 4)

parremove(1M) parremove(1M)

EXAMPLES

Remove the inactive partition whose PartitionNumber is 2:

parremove -p 2

Remove an inactive partition in the same complex as the remote host Penzance. The command prompts for

the root password:

parremove -p 0 -u root: -h Penzance

WARNINGS

HP-UX 11i Version 2 is the last HP-UX release on which passing passwd for the

-u and

-g options is sup-

ported. Specifying passwd on the command line will not be supported in future releases. The command

will prompt for the password.

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and certain of its

conﬁguration settings. If you encounter connection errors when using the

-u option, check that the follow-

ing two conditions are satisﬁed:

• Use the

cimconfig command (see cimconﬁg(1M) in the WBEM product documentation) to verify (and

correct if necessary) the setting of the following two variables:

• enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• You must have appended the target partition’s digital certiﬁcate to the local partition’s Trust Store ﬁle.

For the nPartition commands, the Trust Store ﬁle is

/var/opt/wbem/client.pem.

Note: You must have appended the target partition’s digital certiﬁcate to the local partition’s Trust

Store ﬁle. For the npartition commands, the Trust Store ﬁle is

/var/opt/wbem/client.pem.

This ﬁle is used by the commands that come with WBEM installation. Hence, if the commands that

come with the WBEM installation trust a target partition, then npartition commands will also trust the

target partition.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

parremove was developed by the Hewlett-Packard Company.