HP-UX Reference (11i v2 07/12) - 1M System Administration Commands A-M (vol 3)

f
fcmsutil(1M) fcmsutil(1M)
get local
get fabric
get remote
{all|remote-N-Port-ID
}
This option is used to obtain Fibre Channel login parameters of either the
local port, the
fabric port, or a remote port. The Fibre Channel HBAs do not support the
local
option. If the all argument is specified for the
remote option, login parameters and
current states of all N_Ports that the initiator is aware of, are displayed.
[
-f] reset This option is used to reset the HBA (or a single FC port in case of multi-port HBAs).
WARNING: This is a DESTRUCTIVE test. The reset operation will result in aborting com-
munication to all nodes till the process is completed.
The -f option can be used to suppress the warning message displayed by the Fibre Chan-
nel driver utility.
[-f] bdr target-device_file
This option is used to issue a Bus Device Reset to device.
WARNING: This is a DESTRUCTIVE test.
The -f option can be used to suppress the warning message displayed by the Fibre Chan-
nel driver utility.
This option resets the target, clearing all commands, without doing any checks.
read_cr This option can be used to read all of the readable registers on the card and format the
detailed information.
stat [-s] This option is used to obtain detailed statistics maintained by the driver. An optional argu-
ment -s can be specified to obtain a shortened version of the statistics maintained by the
driver. Generally, the link statistics for the HBA port is displayed.
clear_stat This option is used to clear the statistics maintained by the driver.
nsstat This option is used to obtain detailed nameserver statistics maintained by the driver.
clear_nsstat
This option is used to clear the nameserver statistics maintained by the driver.
devstat {all|remote-N-Port-ID
}
This option is used to obtain detailed statistics associated with each N_Port that this
N_Port has communicated with.
If the remote-N-Port-ID is specified, then the statistics associated with that N_Port are
displayed. If the
all option is specified, statistics associated with all N_Ports that the ini-
tiator has been able to communicate with are displayed. Along with the statistics for each
N_Port, it also displays the loop_id (in Private Loop) and the nport_id (in Fabric).
clear_devstat {all|
remote-N-Port-ID}
This option is used to clear the statistics associated with a target.
If the remote-N-Port-ID is specified, then the statistics associated with that N_Port are
cleared. If the
all option is specified, statistics associated with all valid N_Port_IDs are
cleared.
replace_dsk remote-N-Port-ID
This option is used to specify that no authentication should be performed the next time we
communicate with the device. This option is to be used by system administrators for
replacing a disk, with another (with the same N_Port_ID). Note that this is not required, if
the new disk acquires a new N_Port_ID.
[-f] disable
This option is used to disable the card.
WARNING: This is a DESTRUCTIVE test and communication to all nodes will be ter-
minated.
The -f option can be used to suppress the warning message displayed by the Fibre Chan-
nel driver utility.
HP-UX 11i Version 2: December 2007 Update − 4 − Hewlett-Packard Company 251