HP-UX Reference (11i v2 07/12) - 1 User Commands N-Z (vol 2)

t
telnet(1) telnet(1)
the interrupt character is typed, a TELNET IP sequence (see
send ip above)
is sent to the remote host. The initial value for the interrupt character is taken
to be the terminal’s
intr character.
quit If telnet is in localchars mode (see
toggle localchars below) and
the
quit character is typed, a TELNET BRK sequence (see
send brk above)
is sent to the remote host. The initial value for the quit character is taken to be
the terminal’s
quit character.
flushoutput
If telnet is in localchars mode (see toggle localchars
below)
and the
flushoutput character is typed, a TELNET AO sequence (see
send ao above) is sent to the remote host. The initial value for the flush char-
acter is ˆO.
erase If telnet is in localchars mode (see
toggle localchars below),
and if
telnet is operating in character-at-a-time mode, then when this charac-
ter is typed, a TELNET EC sequence (see
send ec above) is sent to the
remote system. The initial value for the erase character is taken to be the
terminal’s
erase character.
kill If telnet is in localchars mode (see toggle localchars below),
and if telnet is operating in character-at-a-time mode, then when this charac-
ter is typed, a TELNET EL sequence (see send el above) is sent to the
remote system. The initial value for the kill character is taken to be the
terminal’s kill character.
eof If telnet is operating in line-by-line mode, entering this character as the first
character on a line causes this character to be sent to the remote system. The
initial value of the eof character is taken to be the terminal’s eof character.
toggle arguments ...
Toggle (between TRUE and FALSE ) various flags that control how
telnet responds to
events. More than one argument can be specified. The state of these flags can be shown by
using the
display command. Valid arguments are:
localchars
If TRUE, the flush, interrupt, quit, erase, and kill characters (see
set above) are recognized locally, and transformed into appropriate TELNET
control sequences (respectively ao,
ip, brk, ec, and el; see send above).
The initial value for this toggle is
TRUE in line-by-line mode, and FALSE in
character-at-a-time mode.
autoflush
If autoflush and localchars are both TRUE, whenever the ao, intr,
or quit characters are recognized (and transformed into TELNET sequences −
see set above for details), telnet refuses to display any data on the user’s
terminal until the remote system acknowledges (via a TELNET Timing Mark
option) that it has processed those TELNET sequences. The initial value for this
toggle is TRUE.
autologin
This flag is available only in a secure environment based on Kerberos V5.
Enable or disable automatic login into the Kerberos realm. Using this option
yields the same results as using the -a option. The initial value for this toggle
is TRUE.
autosynch
If autosynch and localchars are both TRUE, when either the intr or
quit character is typed (see set above for descriptions of the intr and
quit characters), the resulting TELNET sequence sent is followed by the TEL-
NET SYNCH sequence. This procedure causes the remote system to begin dis-
carding all previously typed input until both of the TELNET sequences have
been read and acted upon. The initial value of this toggle is FALSE.
binary Enable or disable the TELNET BINARY option on both input and output. This
option should be enabled in order to send and receive 8-bit characters to and
from the TELNET server.
HP-UX 11i Version 2: December 2007 Update − 4 − Hewlett-Packard Company 343