HP-UX Reference (11i v2 04/09) - 1M System Administration Commands N-Z (vol 4)

parmodify(1M) parmodify(1M)

Examples of such actions include:

• Assigning an iCOD cell to a partition, specifying "y" for the cell’s use_on_next_boot ﬁeld.

• Changing an iCOD cell’s use_on_next_boot ﬁeld to "y" after assigning it to a partition.

• Assigning a cell containing iCOD-licensed CPUs to a partition that is not running, or that does not

have the iCOD software installed.

For more information about actions that are restricted on iCOD partitions, refer to the iCOD User’s Guide

located at /usr/share/doc/icodUserGuide.pdf.

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and certain of its

conﬁguration settings. If you encounter connection errors when using the

-u option, check that the fol-

lowing two conditions are satisﬁed:

• Use the cimconﬁg(1M) command to verify (and correct if necessary) the setting of the following two

variables:

•

enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• You must have appended the target partition’s digital certiﬁcate to the local partition’s Trust Store ﬁle.

For the nPartition commands, the Trust Store ﬁle is

/var/opt/wbem/client.pem.

Note : You must have appended the target partition’s digital certiﬁcate to the local partition’s Trust

Store ﬁle. For the npartition commands, the Trust Store ﬁle is

/var/opt/wbem/client.pem.

This ﬁle is used by the commands that come with WBEM installation. Hence, if the commands that

come with the WBEM installation trust a target partition, then npartition commands will also trust

the target partition.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

parmodify was developed by the Hewlett-Packard Company.