HP-UX Reference (11i v2 04/09) - 1M System Administration Commands A-M (vol 3)

amutil(1M) amutil(1M)

The command failed due to a device error, an internal error, or a system error. The Additional

Error Info and Error Info Decode ﬁelds will hold speciﬁcs about the failure and its cause.

EXAMPLES

Flash the amber LEDs on all the disks in disk array RACK_51:

amutil -F RACK_51

Stop ﬂashing the amber LEDs on disk array RACK_51:

amutil -s RACK_51

The following example alters the rebuild priority settings. It assigns a value of 5 seconds to the rebuild

command rate, and sets the data block amount to 16 blocks on LUN 4 on disk array RACK_51. This gives

host I/Os higher priority than the default settings.

amutil -R 4 -f 50 -a 16 RACK_51

DEPENDENCIES

AM60Srvr must be running to execute this command. See AM60Srvr(1M).

AUTHOR

amutil was developed by HP.