HP-UX Reference (11i v2 04/09) - 1M System Administration Commands A-M (vol 3)

c
create_sysfile(1M) create_sysfile(1M)
NAME
create_sysfile - create a kernel system file
SYNOPSIS
/usr/lbin/sysadm/create_sysfile
[outfile]
DESCRIPTION
The
create_sysfile
command creates a kernel configuration description file (system file) which can
be used as input to the commands kconfig(1M) or mk_kernel(1M). The system file that is generated is of
type version 1 (see system(4)) and is built according to the drivers required by the current system
hardware. This command is intended for use during the install process when the system does not have a
system file.
The
create_sysfile
command uses a template file as a starting point and then it scans the system
hardware and adds all drivers it can identify to run the existing hardware. If outfile is specified, the
resulting system file is sent to outfile.Ifoutfile is not specified, the output is placed in the file
/stand/system
.
RETURN VALUE
Upon completion,
create_sysfile
returns with one of the following exit values:
0 Successful.
1 One or more errors were reported.
DIAGNOSTICS
Errors are sent to stderr. Most of the diagnostic messages from
create_sysfile
are self-explanatory.
Errors cause
create_sysfile to halt immediately.
AUTHOR
create_sysfile was developed by HP.
FILES
/usr/conf/gen/templates/*
SEE ALSO
kconfig(1M), mk_kernel(1M), system(4), kconfig(5).
Section 1M−−110 Hewlett-Packard Company − 1 − HP-UX 11i Version 2: September 2004