HP-UX Reference (11i v2 04/09) - 1 User Commands N-Z (vol 2)

s
stty(1) stty(1)
ienqak (-ienqak) Enable (disable) ENQ-ACK Handshaking.
brkint (-brkint) Signal (do not signal) INTR on break.
ignpar (-ignpar) Ignore (do not ignore) parity errors.
parmrk (-parmrk) Mark (do not mark) parity errors (see termio (7)).
inpck (-inpck) Enable (disable) input parity checking.
istrip (-istrip) Strip (do not strip) input characters to seven bits.
inlcr (-inlcr) Map (do not map) newline character to carriage return (CR) on input.
igncr (-igncr) Ignore (do not ignore) CR on input.
icrnl (-icrnl) Map (do not map) CR to a newline character on input.
iuclc (-iuclc) Map (do not map) uppercase alphabetic characters to lowercase on input.
ixon (-ixon) Enable (disable) START/STOP output control. Output is stopped by sending
an ASCII DC3 and started by sending an ASCII DC1.
ixany (-ixany) Allow any character (only DC1) to restart output.
ixoff (-ixoff) Request that the system send (not send) START/STOP characters when the
input queue is nearly empty/full.
imaxbel (-imaxbel) Echo (do not echo) BEL when the input line is too long.
Output Modes
opost (-opost) Post-process output (do not post-process output; ignore all other output
modes).
olcuc (-olcuc) Map (do not map) lowercase alphabetics to uppercase on output.
onlcr (-onlcr) Map (do not map) newline character to a carriage-return/newline character
sequence on output.
ocrnl (-ocrnl) Map (do not map) CR to newline character on output.
onocr (-onocr) Do not (do) output CRs at column zero.
onlret (-onlret) On the terminal, a newline character performs (does not perform) the CR
function.
ofill (-ofill) Use fill characters (use timing) for delays.
ofdel (-ofdel) Fill characters are DELs ( NULs).
cr0 cr1 cr2 cr3 Select style of delay for carriage returns (see termio (7)).
nl0 nl1 Select style of delay for newline characters (see termio(7)).
tab0 tab1 tab2 tab3
Select style of delay for horizontal tabs (see termio(7).
bs0 bs1 Select style of delay for backspaces (see termio(7)).
ff0 ff1 Select style of delay for form-feeds (see termio (7)).
vt0 vt1 Select style of delay for vertical tabs (see termio(7)).
Local Modes
isig (-isig) Enable (disable) the checking of characters against the special control charac-
ters INTR and QUIT.
icanon (-icanon) Enable (disable) canonical input (ERASE and KILL processing).
iexten (-iexten) Enable (disable) any implementation-defined special control characters not
currently controlled by icanon, isig,orixon.
xcase (-xcase) Canonical (unprocessed) uppercase and lowercase presentation.
echo (-echo) Echo back (do not echo back) every character typed.
echoe (-echoe) Echo (do not echo) ERASE character as a backspace-space-backspace string.
Note: this mode erases the ERASEed character on many CRT terminals.
HP-UX 11i Version 2: September 2004 − 2 − Hewlett-Packard Company Section 1−−895