HP-UX Reference (11i v2 03/08) - 5 Miscellaneous Topics, 7 Device (Special) Files, 9 General Information, Index (vol 9)

n
nswapfs(5) nswapfs(5)
(Tunable Kernel Parameters)
NAME
nswapfs - maximum number of file systems that can be enabled for swap
VALUES
Default
10 file systems
Allowed values
Minimum:
0 file systems
Maximum:
25 files systems
DESCRIPTION
File system swap devices are managed in a table for easier indexing in the kernel.
nswapfs sets the
kernel variable responsible for the upper limit on this table, and thus the upper limit to file systems
which can be used for swap.
Who is Expected to Change This Tunable?
Anyone.
Restrictions on Changing
Changes to this tunable take effect at the next reboot.
When Should the Value of This Tunable Be Raised?
If another file system swap is added to the system which would increase the number above
nswapfs,
then
swapon() returns [ENOENT] to the caller (see the swapon(2) manpage).
What Are the Side Effects of Raising the Value?
More file systems for swap can be added to the system, and the kernel will need a little more memory for
the table. A small performance side effect of the kernel having to scan more file systems to check for a
duplicate during swapon is also true, but realistically negligible.
When Should the Value of This Tunable Be Lowered?
Only if you are sure the system will never go over a certain number of swap file systems, and you wish to
lower this tunable to save a small amount of kernel memory and kernel performance during swapon
operations.
What Are the Side Effects of Lowering the Value?
No side effects other than the primary and presumably desired new limitation on the number of swap file
systems.
What Other Tunable Values Should Be Changed at the Same Time?
None.
WARNINGS
All HP-UX kernel tunable parameters are release specific. This parameter may be removed or have its
meaning changed in future releases of HP-UX.
AUTHOR
nswapfs was developed by HP.
Section 5−−210 Hewlett-Packard Company − 1 − HP-UX 11i Version 2: August 2003