HP-UX Reference (11i v2 03/08) - 1M System Administration Commands N-Z (vol 4)

p
parremove(1M) parremove(1M)
Layer (SSL) connection. If errors are reported, check that the conditions described
in the DEPENDENCIES section are satisfied.
-h IPaddress|hostname
This option should only be used in combination with either the
-u or -g option.
IPaddress|hostname specifies the IP address or hostname of the target partition (
-
u) or complex (-g).
-g [passwd] Allows access to the complex specified by the
-h option. The accessed complex is
then considered the target complex. Access is via the service processor’s LAN port.
The
-h option is required if this option is used.
passwd specifies the IPMI password of the service processor. If this field is omitted,
the command prompts for the password.
If an error is reported when you attempt to connect using this option, check to see
that IPMI LAN access has not been disabled on the remote service processor.
Access to the complex via IPMI over LAN can be enabled or disabled by logging on
to the service processor and using the
SA
command from the Command Menu.
The
-u and -g options are mutually exclusive.
-F Forcibly remove the partition. This option is required if you are removing your own
local partition, which is active by definition, or if you are using the -g
option to
remove an active partition in the target complex. It is ignored otherwise.
If you are removing an active partition, the partition is marked for removal. This
action is irreversible. However, the partition is not actually removed until it is
shutdown using the
-R[-H] option of the shutdown(1M) command.
-k s_lock :p_lock Note: The
-k option is intended for use by system management tools which invoke
the
parremove command programmatically. Command line users should avoid
this option.
The
-k option specifies the lock keys provided by Partition Manager (parmgr) for
Complex Configuration Data and Partition Configuration Data.
Lock keys should always be specified in pairs. If either lock key is not available,
enter
-1 as a placeholder. For example, if the s_lock key is available but the p_lock
key is not, then the option should be specified as
-k s_lock:-1
.
RETURN VALUE
The
parremove command exits with one of the following values:
0 Successful completion.
1 Error condition occurred.
EXAMPLES
Remove the inactive partition whose PartitionNumber is 2:
parremove -p 2
Remove an inactive partition in the same complex as the remote host Penzance. The command prompts
for the root password:
parremove -p 0 -u root: -h Penzance
DEPENDENCIES
This command uses the Web-Based Enterprise Management (WBEM) product and certain of its
configuration settings. If you encounter connection errors when using the -u option, check that the fol-
lowing two conditions are satisfied:
• Use the cimconfig(1M) command to verify (and correct if necessary) the setting of the following two
variables:
•
enableRemotePrivilegedUserAccess=true
• enableHttpsConnection=true
• You must have appended the target partition’s digital certificate to the local partition’s Trust Store file.
For the nPartition commands, the Trust Store file is /var/opt/wbem/client.pem.
Section 1M−−596 Hewlett-Packard Company − 2 − HP-UX 11i Version 2: August 2003