HP-UX Reference (11i v2 03/08) - 1M System Administration Commands A-M (vol 3)

m
mksf(1M) mksf(1M)
-r -s Special File Name
yes no rdsk/ccardttargetddevice and
rfloppy/ccardttargetddevice
yes yes rdsk/ccardttargetddevicessection
no no dsk/ccardttargetddevice and
floppy/ccardttargetddevice
no yes dsk/ccardttargetddevicessection
hil
Note that only one of -a,
-k,or-r is allowed.
-a address The link address (1-7).
-k Cooked keyboard.
-n The hil controller device.
special-file The default special file name depends on the
-a, -k, and -r options:
Option Special File Name
-a hil_card.address
-k hilkbd_card
-r rhil_card
Note the underscore (_) before card. Also note that for card 0, each file will be
linked to a simpler name without _card, either hiladdress, hilkbd,orrhil
.
lan0 lan1 lan2 lan3
Note that only one of -e or -i is allowed.
-e Ethernet protocol.
-i IEEE 802.3 protocol.
-t Transparent mode (normally used by diagnostics).
special-file The default special file name depends on the
-e, -i
, and -t options:
Option -t Special File Name
-e no ethercard
-e yes diag/ether card
-i no lancard
-i yes diag/lancard
lantty0
-e Exclusive access.
special-file The default special file name depends on whether the
-e option is used:
-e Special File Name
no lanttycard
yes diag/lanttycard
lpr2 lpr3
-c Capital letters. Convert all output to uppercase.
-e Eject page after paper-out recovery.
-n No form-feed.
-o Old paper-out behavior (abort job).
-r Raw.
-t Transparent mode (normally used by diagnostics).
-w No wait. Don’t retry errors on open.
special-file The default special file name depends on whether the
-r option is used:
HP-UX 11i Version 2: August 2003 − 5 − Hewlett-Packard Company Section 1M−−441