HP-UX Reference (11i v2 03/08) - 1M System Administration Commands A-M (vol 3)

disksecn(1M) disksecn(1M)

(Series 800 Only)

This adjustment also takes place when the disk name is known and an assumed sector size (block size) is

passed in as the argument of the -b switch which is not

DEV_BSIZE bytes, the assumed sector size (block

size) used to create the etc/disktab ﬁle.

RETURN VALUE

disksecn returns the following values:

0 Successful completion.

1 Usage error.

2 User did not input parameters for an unknown disk.

3 Disk too small or an invalid block size.

disksecn aborts and prints an error message under the following conditions:

• disksecn was invoked without specifying a disk name.

• Requested both -p and -d switch.

• Illegal block size requested.

• Unknown disk name was speciﬁed and user did not supply disk information.

• Disk’s maximum storage space is less than approximately 44 MB.

WARNINGS

Alternate names are not included in the output when the -d switch is used.

Blanks are required in the command line between each of the switches when invoking disksecn.

A blank is required between the -n switch and the disk name argument to that switch. For example:

disksecn -p -b 1024 -n hp9712

disksecn does not save the block size used to generate the /etc/disktab disk description ﬁle. The system

assumes that the block size used was

DEV_BSIZE when it reads the information stored in the etc/disktab

ﬁle.

AUTHOR

disksecn was developed by the University of California, Berkeley.

FILES

/etc/disktab