HP-UX Reference (11i v2 03/08) - 1M System Administration Commands A-M (vol 3)

d
dhcpv6d(1M) dhcpv6d(1M)
SLP-scope-list=
scope-list ;
This tag specifies the scope list. The scope list should be as per the format
specified in RFC 2165.
The message transaction configuration values are as listed below:
min-sol-delay=
seconds;
This tag specifies the minimum allowable delay (in seconds) before the first SOLI-
CIT message is sent.
max-sol-delay=
seconds;
This tag specifies the maximum allowable delay (in seconds) before the first SOLI-
CIT message is sent.
adv-msg-timeout=
milliseconds ;
This tag specifies the time (in milliseconds), for which the client will wait for the
ADVERTISE message.
adv-msg-max=seconds;
This tag specifies the maximum advertise message timeout value in seconds.
sol-max-attempts=
value;
This tag specifies the maximum number of times the SOLICIT message will be
(re)sent to the server.
rep-msg-timeout=milliseconds
;
This tag specifies the time by which the REQUEST message times out.
req-msg-attempts=
value;
This tag specifies the maximum number of attempts the client makes to deliver the
REQUEST message to the server to get a response.
rel-msg-attempts=
value;
This tag specifies the maximum number of attempts the client makes to deliver the
RELEASE message to the server to get a response.
rec-rep-min=value;
This tag specifies the minimum pause interval (in seconds) before the REQUEST
message is sent in response to the RECONFIGURE-INIT message.
rec-rep-max=value;
This tag specifies the maximum pause interval (in seconds) before the REQUEST
message is sent in response to the RECONFIGURE-INIT message.
Note: Currently, the mechanism of transferring these parameters to the client is not
defined in RFCs. This may be made possible in the future releases.
The tags applicable for the individual DHCPv6 pool groups are as listed below:
DHCP_POOL_GROUP;
This tag specifies the individual pool groups.
pool-group-name=name-of-the-pool-group
;
This tag specifies the name of the pool group as an ASCII string.
default-settings=default-settings-name
;
This tag specifies the default settings for the pool group.
subnet-prefix=IPv6-hex-address-format
;
This tag specifies the subnet-prefix of the network that the server manages. Note
that you need to specify the complete address of the subnet.
prefix-length=unsigned-integer;
This tag specifies the length of the subnet-prefix.
address-pool=start_addr1 - end_addr1 start_addr2 - end_addr2... ;
This tag specifies the list of start and end address, which constitute the address
pool.
reserved-address-list=start_addr1 - end_addr1 start_addr2 - end_addr2... ;
This tag specifies the start and end addresses of the list of addresses, which consti-
tute the reserved addresses of the address pool.
Section 1M−−134 Hewlett-Packard Company − 3 − HP-UX 11i Version 2: August 2003