HP-UX Reference (11i v2 03/08) - 1M System Administration Commands A-M (vol 3)

cplxmodify(1M) cplxmodify(1M)

The -h option is required if this option is used.

passwd speciﬁes the IPMI password of the service processor. If this ﬁeld is omitted, the

command prompts for the password.

If an error is reported when you attempt to connect using this option, check to see that

IPMI LAN access has not been disabled on the remote service processor. Access to the

complex via IPMI over LAN can be enabled or disabled by logging on to the service pro-

cessor and using the

SA command from the Command Menu.

The

-u and -g options are mutually exclusive.

RETURN VALUE

The

cplxmodify command exits with one of the following values:

0 Successful completion.

1 Error condition occurred.

EXAMPLES

Change the name of the local complex to "Basingstoke".

cplxmodify -N Basingstoke

Change the name of a remote complex to "Ploverleigh". The command prompts for the password.

cplxmodify -N Ploverleigh -g -h RemoteComplex

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and certain of its

conﬁguration settings. If you encounter connection errors when using the

-u option, check that the fol-

lowing two conditions are satisﬁed:

• Use the cimconﬁg(1M) command to verify (and correct if necessary) the setting of the following two

variables:

•

enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• You must have appended the target partition’s digital certiﬁcate to the local partition’s Trust Store ﬁle.

For the nPartition commands, the Trust Store ﬁle is

/var/opt/wbem/client.pem.

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

cplxmodify was developed by the Hewlett-Packard Company.