HP-UX Reference (11i v2 03/08) - 1 User Commands A-M (vol 1)

l
ld(1) ld(1)
allocation, thus reduce TLB misses by allowing the kernel to allocate fewer, larger
data pages. Use of this option increases your output file size.
+pd size Request a particular virtual memory page size that should be used for data. Sizes
of 4K, 16K, 64K, 256K
, 1M, 4M, 16M, 64M, 256M, D, and L are supported. A size
of
D allows the kernel to choose what page size should be used. A size of
L results
in using the largest page size available. The actual page size may vary if the
requested size cannot be fulfilled.
+pdzero This option is ignored.
+pgm name With the -P option, specify that name should be used as the look-up name in the
profile database file. The default is the basename of the output file (specified by the
-o option.) This option is incompatible with the
+ild option.
+pi size Request a particular virtual memory page size that should be used for instructions.
See the +pd option for additional information.
+plabel_cache flag
This option is ignored.
+profilebucketsize
[16|32]
Specifies the size of the profiling sample counter buckets. Valid values are 16 or 32.
See gprof(1) for more details.
+s This option is the default. Indicate that at run-time, the dynamic loader can use the
environment variables SHLIB_PATH and LD_LIBRARY_PATH
to locate shared
libraries needed by the executable output file that allow dynamic library searching.
Shared libraries that allow dynamic library searching either contain an internal
name without the "/" (slash) character (for example, the base name of the shared
library pathname) or have no internal name and were specified with either
-l or -
L, or just the base name of the shared library pathname. The environment vari-
ables should be set to a colon-separated list of directories.
In compatibility mode using the
+compat option, if both +s and +b are used,
their relative order on the command line indicates which path list is searched first
(see the
+b option). In standard mode (default mode or using the +std option),
the order of +s and +b does not affect the dynamic loader search order and the
environment variables are always searched first.
+rpathfirst
This option will cause the paths specified in RPATH (embedded path) to be used
before the paths specified in LD_LIBRARY_PATH
or SHLIB_PATH, in searching
for shared libraries. This changes the default search order of
LD_LIBRARY_PATH
,
SHLIB_PATH, and RPATH (embedded path).
+std This option is the default. Turn on standard mode of the linker. This option is the
complement of the
+compat option. Options set on with this option are:
-dynamic. Options set off or ignored when this option is specified are: +compat,
+noenvvar, -noshared.
+stripunwind
Do not output the unwind table. This creates smaller executable sizes. Use this
option if you do not need the unwind table for debugging or aC++ exception han-
dling.
Note: Use of the
+stripunwind option might impair or prevent the use of a sym-
bolic debugger on the resulting program.
+tools This option is ignored.
+vallcompatwarnings
This option is ignored.
+v[no]compatwarnings
This option is ignored.
+v[no]shlibunsats
Enable [disable] printing a list of unsatisfied symbols used by shared libraries. The
default is +vnoshlibunsats. Some unsatisfied symbols reported by the linker
are not required at run time because the modules which reference the symbols are
HP-UX 11i Version 2: August 2003 − 12 − Hewlett-Packard Company Section 1−−441