HP-UX Reference (11i v2 03/08) - 1 User Commands A-M (vol 1)

f
ftp(1) ftp(1)
send local-file [ remote-file ]
A synonym for put.
sendport
Toggle the use of
PORT commands. By default, ftp attempts to use a PORT command when
establishing a connection for each data transfer. If the
PORT command fails, ftp uses the default
data port. When the use of
PORT commands is disabled,
ftp makes no attempt to use PORT com-
mands for each data transfer. This is useful for certain FTP implementations that ignore
PORT
commands but (incorrectly) indicate that they’ve been accepted. See ftpd(1M). Turning
sendport
off may cause delays in the execution of commands.
site arguments
Send arguments , verbatim, to the server host as a
SITE command. See ftpd(1M).
size remote-file
Show the size of remote-file.
status
Show the current status of ftp.
struct [ struct-name ]
Set the FTP file transfer struct to struct-name . The only supported struct is
file.
sunique
Toggle storing of files on remote machine under unique file names. The remote server reports the
unique name. By default, sunique is off.
system
Show the type of operating system running on the remote machine.
tenex
Set the FTP file transfer type to tenex.
type [ type-name ]
Set the FTP file transfer type to type-name .Iftype-name is unspecified, write the current type to
stdout.
Ascii, binary, and tenex are the types currently supported.
umask [ newmask ]
Set the default umask on the remote server to newmask.Ifnewmask is omitted, the current umask
is printed.
user user-name [ password ][account ]
Log into the server host on the current connection, which must already be open. A .netrc
file in
the user’s local home directory can provide the user-name , password, and optionally the account ;
see netrc(4). Otherwise
ftp prompts the user for this information. The HP-UX FTP server does
not require an account . For security reasons, ftp always requires a password. It does not log into
remote accounts that do not have a password.
In a secure environment based on Kerberos V5,
ftp will not require a password. Instead, Kerberos
authentication and authorization will be performed as described in sis(5). In all other environ-
ments, users are considered authenticated if they have a password and that password is correct, and
authorized if an account exists for them on the remote system.
verbose
Toggle verbose output. If verbose output is enabled, ftp displays responses from the server host,
and when a file transfer completes it reports statistics regarding the efficiency of the transfer.
? [ command ]
A synonym for the help command. Prints the help information for the specified command.
Aborting A File Transfer
To abort a file transfer, use the terminal interrupt key (usually Ctrl-C). Sending transfers are halted
immediately.
ftp halts incoming (receive) transfers by first sending a FTP protocol ABOR command to
the remote server, then discarding any further received data. The speed at which this is accomplished
depends upon the remote server’s support for ABOR processing. If the remote server does not support the
ABOR command, an ftp> prompt does not appear until the remote server completes sending the
requested file.
The terminal interrupt key sequence is ignored while
ftp awaits a reply from the remote server. A long
delay in this mode may result from the ABOR processing described above, or from unexpected behavior
HP-UX 11i Version 2: August 2003 − 6 − Hewlett-Packard Company Section 1−−311