HP-UX Reference (11i v1 05/09) - 5 Miscellaneous Topics (vol 9)

p
pd_att_phy_ptr(5) pd_att_phy_ptr(5)
(TO BE OBSOLETED)
| Attribute | Description |
|------------|-----------------------------------------------------------|
| Name | attachment-type |
|------------|-----------------------------------------------------------|
| Type | Specifiable with the pdcreate command. |
|------------|-----------------------------------------------------------|
| Usage | Values vary by printer model. |
|------------|-----------------------------------------------------------|
| Explanation| Identifies how the physical printer device represented by |
| | this physical printer is attached to the supervisor and |
| | how the supervisor is to communicate with the physical |
| | printer device. |
|------------|-----------------------------------------------------------|
| Value Type | Single value. |
|------------|-----------------------------------------------------------|
| Values | One of the following fixed values: |
|| |
| | tcpip supervisor will communicate with |
| | this printer via the TCP/IP network |
| | with TCP port 910X protocol. The |
| | printer must be a network peripheral. |
| | This protocol is supported by some HP |
| | JetDirect products. |
|| |
| | tcpip-bsd supervisor will communicate with |
| | this printer via the TCP/IP network |
| | with the BSD (lpd) protocol. The |
| | printer must be a network peripheral. |
| | This protocol is supported by some HP |
| | JetDirect products. |
|| |
| | serial supervisor will communicate with |
| | this printer via the serial interface.|
|| |
| | parallel supervisor will communicate with |
| | this printer via the parallel |
| | interface. |
|| |
| | lp-spool-hp supervisor will communicate with |
| | this printer using the lp spooler |
| | protocol for an HP-UX system. The |
| | printer must belong to an lp spooler |
| | on an HP-UX host. |
|| |
| | lp-spool-bsd supervisor will communicate with |
| | this printer using the BSD (lpd) |
| | spooler protocol. The printer must |
| | belong to an lp/lpr spooler on a non- |
| | HP-UX host. |
|------------|-----------------------------------------------------------|
| Default | No default. |
|------------|-----------------------------------------------------------|
| Usage | o Must be set with the pdcreate command at the time of |
| Guidelines | creation. |
| | o This attribute is validated against the printer |
| | attachment-types-supported attribute. |
|------------|-----------------------------------------------------------|
|------------|-----------------------------------------------------------|
| Attribute | Description |
|------------|-----------------------------------------------------------|
| Name | attachment-types-supported |
|------------|-----------------------------------------------------------|
Section 5−−210 Hewlett-Packard Company − 3 − HP-UX 11i Version 1: September 2005