HP-UX Reference (11i v1 05/09) - 1M System Administration Commands N-Z (vol 4)

v
vparboot(1M) vparboot(1M)
• vp_name is in some state other than
Down, and so cannot be booted. Use the vparreset command
instead.
• An error occurs while trying to access an Ignite server or cold-install file.
You have specified the
BOOT, TAPE,orALTBOOT device, but the corresponding device has not been
configured in vp_name.
Note: If the boot device has not been configured properly the
vparboot command will complete
without error, but the virtual partition will not boot. Possible reasons for this could be:
— The
BOOT or ALTBOOT attribute was assigned to a device other than a disc or tape.
— The TAPE attribute was assigned to a device other than tape.
— The file at the default or configured kernel path does not exist or is not a bootable image.
• The vparboot command and the virtual partition monitor are at different revision levels. This mes-
sage is only a warning. The command continues.
AUTHOR
vparboot was developed by the Hewlett-Packard Company.
SEE ALSO
vparadmin(1M), vparcreate(1M), vparmodify(1M), vparremove(1M), vparreset(1M), vparstatus(1M), vpar-
resources(5), vpartition(5), vpmon(5).
Section 1M−−1098 Hewlett-Packard Company − 3 − HP-UX 11i Version 1: September 2005