HP-UX Reference (11i v1 05/09) - 1M System Administration Commands N-Z (vol 4)
s
swconfig(1M) swconfig(1M)
(HP-UX Software Distributor)
1
enables verbose logging to the logfiles.
2 enables very verbose logging to the logfiles.
mount_all_filesystems=true
By default, the swconfig command attempts to automatically mount all filesystems in
the /etc/fstab file at the beginning of the analysis phase, to ensure that all listed
filesystems are mounted before proceeding. This policy helps to ensure that files are not
loaded into a directory that may be below a future mount point.
If set to false, the mount operation is not attempted, and no check of the current mounts
is performed.
reconfigure=false
Prevents software which is already in the CONFIGURED state from being reconfigured. If
set to true, CONFIGURED software can be reconfigured.
rpc_binding_info=ncacn_ip_tcp:[2121] ncadg_ip_udp:[2121]
Defines the protocol sequence(s) and endpoint(s) on which the daemon listens and on which
the other commands use to contact the daemon. If the connection fails for one protocol
sequence, the next is attempted. SD supports both the tcp (ncacn_ip_tcp:[2121]) and udp
(ncadg_ip_udp:[2121]) protocol sequence on most platforms.
rpc_timeout=5
Relative length of the communications timeout. This is a value in the range from 0 to 9 and
is interpreted by the DCE RPC. Higher values mean longer times; you may need a higher
value for a slow or busy network. Lower values will give faster recognition on attempts to
contact hosts that are not up, or are not running the swagentd. Each value is approxi-
mately twice as long as the preceding value. A value of 5 is about 30 seconds for the
ncadg_ip_udp protocol sequence.
run_as_superuser=true
This option controls SD’s nonprivileged mode. This option is ignored (treated as true) when
the invoking user is super-user.
When set to the default value of true, SD operations are performed normally, with permis-
sions for operations either granted to a local super-user or set by SD ACLs. (See swacl(1M)
for details on ACLs.)
When set to false and the invoking user is local and is not super-user, nonprivileged mode
is invoked:
• Permissions for operations are based on the user’s file system permissions.
• SD ACLs are ignored.
• Files created by SD have the uid and gid of the invoking user, and the mode of created
files is set according to the invoking user’s umask.
SD’s nonprivileged mode is intended only for managing applications that are specially
designed and packaged. This mode cannot be used to manage the HP-UX operating system
or patches to it. For a full explanation of nonprivileged SD, see the Software Distributor
Administration Guide, available at the
http://docs.hp.com
web site.
See also the
admin_directory and installed_software_catalog
options.
select_local=true
If no target_selections are specified, select the local host as the target of the command.
software=
Defines the default software_selections. There is no supplied default. If there is more than
one software selection, they must be separated by spaces.
targets=
Defines the default target_selections. There is no supplied default (see select_local
above). If there is more than one target selection, they must be separated by spaces.
verbose=1
Controls the verbosity of the output (stdout). A value of
0 disables output to stdout. (Error and warning messages are always written to stderr).
1 enables verbose messaging to stdout.
HP-UX 11i Version 1: September 2005 − 7 − Hewlett-Packard Company Section 1M−−913