HP-UX Reference (11i v1 05/09) - 1M System Administration Commands N-Z (vol 4)

s
sam(1M) sam(1M)
Backup and Recovery
• Interactively back up files to a valid backup device (cartridge tape, cartridge tape autochanger,
magnetic tape, DAT, magneto-optical disk, or magneto-optical disk autochanger). The SAM inter-
face is suspended so that you can read and/or respond to the interactive messages produced by
fbackup (see fbackup(1M)).
• Recover files online from a valid backup device. The SAM interface is suspended so that you can
read/respond to the interactive messages produced by
frecover (see frecover(1M)).
• Add to, delete from, or view the automated backup schedule.
• Obtain a list of files from a backup tape.
• View various backup and recovery log files.
Disk and File Systems Management
• Add, configure, or unconfigure disk devices, including hard drives, floppy drives, CD-ROMs,
magneto-optical devices and disk arrays.
• Add, modify, or remove local file systems, or convert them to long file names.
• Configure HFS or VxFS file systems.
• Remote (NFS) file systems configuration, including:
• Add, modify, or remove remote (NFS) file systems.
• Allow or disallow access by remote systems to local file systems.
• Modify RPC (Remote Procedure Call) services’ security.
• Add, remove, or modify device or file system swap.
• Change the primary swap device.
• Add, modify, or remove dump devices.
• Examine, create, extend, or reduce a volume-group pool of disks.
• Create, extend or change number of mirrored copies of a logical volume and associated file system.
• Remove a logical volume or increase its size.
• Split or merge mirrored copies of a logical volume.
• Share or unshare volume groups (only on ServiceGuard clusters running MC/LockManager distri-
buted lock-manager software).
Kernel and Device Configuration
• Add/remove static drivers and DLKM modules to/from a kernel.
• Modify static and dynamic tunable parameter values in the kernel.
• Modify dump device configuration in the kernel.
• Add or remove optional subsystems such as NFS, LAN, NS, CD-ROM, etc.
• Generate a new kernel.
Networks/Communications
• Configure one or more LAN cards.
• Configure ARPA services.
• Configure the Network File System (NFS).
• Configure X.25 card or cards and PAD (Packet Assembler/Disassembler) services (if X.25 has been
purchased).
Peripheral Devices Management
• Administer the LP spooler or Distributed Print Services and associated printers and plotters (see
"Printer and Plotter Management" below).
• Add, modify, or remove the configuration of disk devices.
HP-UX 11i Version 1: September 2005 − 2 − Hewlett-Packard Company Section 1M−−799