HP-UX Reference (11i v1 05/09) - 1M System Administration Commands N-Z (vol 4)

parmodify(1M) parmodify(1M)

parmodify -p 2 -d 5

WARNINGS

On a partition whose hardware resources are managed under an instant Capacity On Demand (iCOD)

license, the parmodify command fails if a conﬁguration change would take the partition out of compliance.

Examples of such actions include:

• Assigning an iCOD cell to a partition, specifying "y" for the cell’s use_on_next_boot ﬁeld.

• Changing an iCOD cell’s use_on_next_boot ﬁeld to "y" after assigning it to a partition.

• Assigning a cell containing iCOD-licensed CPUs to a partition that is not running, or that does not have

the iCOD software installed.

For more information about actions that are restricted on iCOD partitions, refer to the iCOD User’s Guide

located at /usr/share/doc/icodUserGuide.pdf.

DEPENDENCIES

This command uses the Web-Based Enterprise Management (WBEM) product and certain of its

conﬁguration settings. If you encounter connection errors when using the

-u option, check that the follow-

ing two conditions are satisﬁed:

• Use the cimconﬁg(1M) command to verify (and correct if necessary) the setting of the following two vari-

ables:

•

enableRemotePrivilegedUserAccess=true

• enableHttpsConnection=true

• You must have appended the target partition’s digital certiﬁcate to the local partition’s Trust Store ﬁle.

For the nPartition commands, the Trust Store ﬁle is

/opt/nparcmds/nparcmds.pem

Refer to the WBEM documents speciﬁed in the SEE ALSO section below for further information.

AUTHOR

parmodify was developed by the Hewlett-Packard Company.

FILES

/usr/sbin/ The partition commands under this directory do not provide remote management

feature.

/usr/lib/npar/ The partition commands under this directory provide remote management feature.

These commands use the nPartition Provider product.

/opt/nparprovider/lib/installed

The presence of this ﬁle indicates that nPartition Provider is installed.