HP-UX Reference (11i v1 05/09) - 1M System Administration Commands A-M (vol 3)

a
arraycfg(1M) arraycfg(1M)
The specified operation cannot be performed because it would result in loss of data availability or data
redundancy. The -R and -Z options can be used to override this error.
arraycfg: Disk was not downed, data would be lost.
The specified operation cannot be performed because it would result in loss of data. The
-Z option can
be used to override this error.
arraycfg: A diagnostic is currently running on this disk, cannot
include disk until the diagnostic completes.
An attempt was made to include a disk that is currently undergoing diagnostic testing. Wait until the
diagnostic completes, or cancel the diagnostic using the
dteststat utility.
arraycfg: The specified disk is not installed.
An attempt was made to perform an operation on a disk that is not installed in the array.
arraycfg: The array is in a state that cannot process this command.
The disk array is unable to execute the command. This typically occurs because the disk array is shut-
down. Check disk array status.
arraycfg: Array was just powered-on or reset.
The command failed because the disk array has been powered-on or reset. Reissue the command and
it should succeed.
EXAMPLES
Create LUN 6 with a size of 500 Mbytes on the disk array identified by device file
/dev/rdsk/c2t0d0:
arraycfg -L 6 -a 500 /dev/rdsk/c2t0d0
Renumber LUN 1 to LUN 2 on disk array serial number 00786b5c0000 :
arraycfg -L 1 -r 2 00786b5c0000
Delete LUN 3 on the disk array identified by device file /dev/rdsk/c2t0d0
:
arraycfg -L 3 -d /dev/rdsk/c2t0d0
Include the disk in slot B4 in the configuration of disk array serial number 00786b5c0000
:
arraycfg -D B4 -a 00786b5c0000
Down the disk in slot A3 on disk array serial number 00786b5c0000 . Allow the command to execute
even if redundancy will be lost:
arraycfg -D A3 -d -R 00786b5c0000
DEPENDENCIES
ARMServer must be running to execute this command. See ARMServer(1M).
SECURITY CONFIGURATION
This command is modified for all security configurations.
Security Behavior/Restrictions
Use of this command is restricted to authorized users only.
Command Authorizations
This command requires the sysadmin authorization to successfully execute.
Privileges
The command has been modified to support least privilege. The potential privileges possessed by the com-
mand and their uses include:
allowdacread This privilege is raised to provide discretionary read access to the devices.
allowdacwrite This privilege is raised to provide discretionary write access to the devices.
allowmacread This privilege is raised to provide mandatory read access to the devices.
allowmacwrite This privilege is raised to provide mandatory write access to the devices.
filesysops This privilege is raised to allow the mknod(2) system call to succeed.
Section 1M−−48 Hewlett-Packard Company − 3 − HP-UX 11i Version 1: September 2005