HP-UX Reference (11i v1 05/09) - 1M System Administration Commands A-M (vol 3)

m
mksf(1M) mksf(1M)
-r Special File Name
yes rac/ccardttargetddevice_optical-diska
rac/ccardttargetddevice_optical-diskb
no ac/ccardttargetddevice_optical-diska
ac/ccardttargetddevice_optical-diskb
Note the underscore (_) between device and optical-disk.
CentIf
-h
handshake-mode
Handshake mode. Valid values range from 1 to 6:
handshake-mode Handshake operation
1 Automatic NACK/BUSY handshaking
2 Automatic BUSY only handshaking
3 Bidirectional read/write
4 Stream mode (NSTROBE only, no handshaking)
5 Automatic NACK/BUSY with pulsed NSTROBE
6 Automatic BUSY with pulsed NSTROBE
special-file The default special file name is ccardt0d0_lp for handshake-mode
2 and
ccardt0d0hhandshake-mode
_lp for all others. For SCentIf, the only valid
handshake value is 2 (Automatic BUSY only handshaking).
consp1
-r
fifo-trigger fifo-trigger should have a value between 0 and 3. The following table shows the
corresponding FIFO trigger level for a given fifo-trigger value.
fifo-trigger Receive FIFO Trigger Level
0 1
1 4
2 8
3 14
-t Transparent mode (normally used by diagnostics).
-x xmit-limit xmit-limit should have a value between 0 and 3. The following table shows the
corresponding transmit limit for a given xmit-limit value.
xmit-limit Transmit Limit
0 1
1 4
2 8
3 12
special-file The default special file name is as follows:
Special File Name
ttycardp0
disc3
-f
Floppy.
-r Raw; create character, not block, special file.
-s section The section number.
special-file The default special file name depends on whether the -r and -s options are used:
HP-UX 11i Version 1: September 2005 − 4 − Hewlett-Packard Company Section 1M−−497