HP-UX Reference (11i v1 05/09) - 1M System Administration Commands A-M (vol 3)

lanadmin(1M) lanadmin(1M)

LAN Interface Test Mode Menu

The following commands are available:

clear Clear the LAN interface network statistics registers to zero. You must have

superuser privileges.

display Display the RFC 1213 MIB II statistics. Depending on the link, the type-speciﬁc

MIB statistics may also be displayed. For instance, for Ethernet links, the RFC 1398

Ethernet-like statistics are displayed.

end Return lanadmin to Test Selection Mode.

menu Display the LAN Interface Test Mode command menu.

ppa Prompt for a PPA that corresponds to a LAN interface card. It defaults to the ﬁrst

LAN interface encountered in an internal list. Appropriate values can be displayed

with the

lanscan command (see lanscan(1M)).

quit Terminate the

lanadmin program.

reset Reset the local LAN interface card, causing it to execute its self-test. Local access to

the network is interrupted during execution of reset. You must have superuser

privileges.

specific Display and execute commands from a driver specific menu.

WARNINGS

Changes made to an interface’s station address or mtu interactively with the

lanadmin command will not

be preserved between system reboots. A user must modify the initialization conﬁguration ﬁles for this

feature, either manually editing conﬁguration ﬁles or through the

SAM interface.

AUTHOR

lanadmin was developed by HP.