HP-UX Reference (11i v1 05/09) - 1M System Administration Commands A-M (vol 3)

f
fcmsutil(1M) fcmsutil(1M)
This option resets the target, clearing all commands, without doing any checks. This option
is supported only by TACHYON TL, TACHYON XL2, DUAL PORT and FC/GigE COMBO
cards.
read_cr This option can be used to read all of the readable registers on the card and format the
detailed information.
lgninfo_all (T)
This option is used to obtain a comprehensive list of nodes to which a successful login has
been established. This option is not supported by TACHYON TL, TACHYON XL2, DUAL
PORT and FC/GigE Combo cards.
stat This option is used to obtain detailed statistics maintained by the driver. An optional argu-
ment (-s) can be specified for TACHYON TL and TACHYON XL2 cards, to obtain a shor-
tened version of the statistics maintained by the driver.
clear_stat (TL/XL/QL)
This option is used to clear the statistics maintained by the driver. This option is supported
only by TACHYON TL, TACHYON XL2, DUAL PORT and FC/GigE COMBO cards.
nsstat (TL/XL/QL)
This option is used to obtain detailed nameserver statistics maintained by the driver. This
option is supported only by TACHYON TL, TACHYON XL2, DUAL PORT and FC/GigE
Combo cards .
clear_nsstat (TL/XL/QL)
This option is used to clear the nameserver statistics maintained by the driver. This option
is supported only by TACHYON TL, TACHYON XL2, DUAL PORT and FC/GigE cards.
devstat (TL/XL/QL)
This option is used to obtain detailed statistics associated with each N_Port that this
N_Port has communicated with.
If the remote-N-Port-ID is specified, then the statistics associated with that N_Port are
displayed. If the
all option is specified, statistics associated with all N_ports that the ini-
tiator has been able to communicate with, are displayed.
This option is supported only by TACHYON TL, TACHYON XL2, DUAL PORT and
FC/GigE COMBO cards.
clear_devstat (TL/XL/QL)
This option is used to clear the statistics associated with a target.
If the remote-N-Port-ID is specified, then the statistics associated with that N_port are
cleared. If the
all option is specified, statistics associated with all valid N_Port_IDs are
cleared.
This option is supported only by TACHYON TL, TACHYON XL2, DUAL PORT and
FC/GigE COMBO cards.
replace_dsk (TL/XL/QL)
This option is used to specify that no authentication should be performed the next time we
communicate with the device. This option is to be used by system administrators for
replacing a disk, with another (with the same N_Port_ID). Note that this is not required, if
the new disk acquires a new N_Port_ID.
This option is supported only by TACHYON TL, TACHYON XL2, DUAL PORT and
FC/GigE COMBO cards.
[-f] disable
The disable option is used to disable the card. WARNING: This is a DESTRUCTIVE
test and communication to all nodes will be terminated. The -f option can be used
to suppress the warning message displayed by TACHYON TL, TACHYON XL2, DUAL
PORT and FC/GigE Combo cards.
This option can be used, typically when a hardware problem cannot be resolved and is
interfering with system performance.
enable This option is used to enable the card, typically when a previous hardware problem has
been resolved.
HP-UX 11i Version 1: September 2005 − 5 − Hewlett-Packard Company Section 1M−−225