HP-UX Reference (11i v1 05/09) - 1M System Administration Commands A-M (vol 3)

d
dsp(1M) dsp(1M)
SCSI (device level) communication errors:
Sense data associated with the failed operation is printed.
Error messages generated by system calls:
dsp uses the following system calls:
stat(), open(), close(), read()
, write(), and ioctl().
Documentation for these
HP-UX system calls contains information about the specific error conditions associ-
ated with each call.
dsp does not alter the value of
errno. The interpretation of
errno for printing
purposes is performed by the system utility
strerror() .
EXAMPLES
To display the status of the drives on the
HP SCSI disk array /dev/rdsk/c2t4d0
on a Series 700:
dsp -p /dev/rdsk/c2t4d0
To display the status of the
LUN associated with the HP SCSI disk array /dev/rdsk/c2t0d0
on a Series
800 in raw hex format:
dsp -l -h /dev/rdsk/c2t0d0
To display the status of the drives on the HP SCSI disk array /dev/rdsk/c2t5d0
in raw decimal format
on a Series 700:
dsp -p -d /dev/rdsk/c2t5d0
DEPENDENCIES
The HP C2425 and HP C2427 disk arrays are only supported on Series 700 systems running HP-UX version
9.0X.
The HP C2430 disk array is supported on Series 700 and 800 systems runing HP-UX versions 9.0X and
10.0X.
AUTHOR
dsp was developed by HP.
HP-UX 11i Version 1: September 2005 − 2 − Hewlett-Packard Company Section 1M−−191