HP-UX Reference (11i v1 00/12) - 4 File Formats (vol 8)
__________________________________________________________________________________________________________________________________________________________________________________________________
__________________________________________________________________________________________________________________________________________________________________________________________________
STANDARD Printed by: Nora Chuang [nchuang] STANDARD
/build/1111/BRICK/man4/!!!intro.4
________________________________________________________________
___ ___
b
bootconf(4) bootconf(4)
NAME
bootconf - boot device configuration table
DESCRIPTION
This file, /stand/bootfonf, contains the address and disk layout type of the system’s boot devices or lif
volumes. It is used by the Software Distributor and HP-UX kernel control scripts (fileset OS-
Core.KERN-RUN
) to determine how and where to update the initial boot loader. Normally the kernel’s
checkinstall script queries the system’s hardware and creates the file. In rare cases when either the
system configuration cannot be automatically determined or additional and/or alternate boot devices should
be automatically updated, the administrator must edit the /stand/bootconf file manually.
There is one line in the file for each boot device. Each line contains the following blank-separated fields in
the order shown:
disk type A flag indicating how the file system(s) on the disk are laid out. The flag must be one
of the following:
l Indicates that the root disk is in LVM format. If LVM mirrors are used, then
each of the "mirrors" must have its own line.
p Indicates that the root disk has Series 800-style hard partitions and that the
boot volume is is section 6.
w Indicates that the root disk is in the Release 9.X Series 700-style "whole disk"
format with no partitions, but boot and swap space are reserved outside the
file system.
device file The absolute path of the device special file that accesses the physical device where the
boot area is located. For LVM root disks, the device special file is the physical
volume(s) returned by the vgdisplay -v command. For Series 800 hard parti-
tions, this is the device special file that points to section six of the disk. For Series
700-style "whole disks" this is the device file that references the entire disk.
Blank lines are permitted. Any line beginning with a # is considered to be a comment.
DIAGNOSTICS
The Software Distributor log file /var/adm/sw/swagent.log
contains diagnostic messages under
the
OS-Core.KERN-RUN
fileset if the bootconf file is incorrect. Most of the messages are self-
explanatory; a few warrant additional explanation:
... is either empty or improperly formatted...
If there are no other messages about bootconf, the file is probably empty. Otherwise, the file is not
in the proper format, and the other messages will explain what the problem is.
device file ... does not contain a valid boot LIF ...
The specified device file does not point to a disk where there is a lif which contains the file HPUX.
... has an invalid character in the flag field...
Some character other than #, l, p,orw is in the first field of a line.
... contains contradictory boot LIF types...
As of release 10.0, the boot areas in /stand/bootconf
must all be on the same type of disk lay-
out.
... has unrecognized extra characters...
There are characters after the device file specification.
EXAMPLES
The boot area is on an LVM root disk:
# Boot Device configuration file
# This file contains information regarding the location
# of the boot LIF. It is used by the KERN-RUN fileset to
# update the boot kernel.
l /dev/dsk/c2t7d0
The system has LVM mirroring on root (the device files indicate that the system is running on a 9.0 release
being prepared for updating to 10.0):
Section 4−−30 − 1 − HP-UX Release 11i: December 2000
___
___